Search results

Pleased to report all sorted Fault was the HP Pressure regulator When I removed it the nitrile o ring was broken, surprisingly the nylon backing washer was on pretty good condition Replacement Fitted all running good - thanks for your help all Paul G

No joy with new cam sensor, I have been checking wiring In the ECU compartment there is a relay with some pretty hefty wiring going to it the relay does not click when ign turned on and there is no continuity across the HT side of the relay, a little difficult to test on my own. I am...

Hi Thanks for reply, I didn't know cam sensor was only used in starting, still not getting good readings could be a case of costly elimination :) paul

Cleared codes and 1E25 fault eventually re-appeared, used a different scanner and cleared codes 1E25 came back (after a while) Pulled out the sensor have 12 v and ground signal voltage only 0.2 V no variation in signal voltage when passing a metal object past the sensor So took...

Just dragged a 1E25 fault code out of it, Scanner I am using says undefined But I believe it is cam sensor Any way of testing (without engine running )? Thanks Paul

Yep I am on that track, cam or crank sensor maybe

Hi Guys, Cranking speed is ok there is compression I took off the LP fuel line lots of fuel being delivered By LP pump I cracked an injector pipe plenty of fuel up at the rail ( I was surprised that turning ignition on gave me fuel flow at rail - is this correct ? ) I have swapped...

Hi Artic Hi, Thnks for reply, No diagnosis codes in memory but can't check till I get it running, Good cranking speed even cold I had half expected it to start this morning after a little fuel had found it way through a blocked filter but no Where is best place to check if I have...

On a very long day after 400 plus miles my FL1 cut out at 70 mph, no warning coughs splutters or weird noises and refuses to start Turns over fast no problem. I can hear the wheel arch fuel pump Swapped over / tapped moved relays and checked fuses Think I found the inertia cut off switch...