Search results

Quick update, pads and discs all replaced, and no change. Getting it booked in with Bell Engineering for a diagnosis

I have the same issue in mine and had the injectors done but unfortunately no change. Sounds very similar to this though

Hi, both Camshaft and Crankshaft sensors were replaced and no change

Hi Arctic Rail pressure has been confirmed as ok on cranking. I’ve had a second garage check the injectors and all ok as well. Glow plugs about a year ago from memory. Same with the control module. But I’ve had this issue a long time now (probably 2.5 years), and didn’t notice a difference after...

Hi Arctic, Cable was replaced for the 240 amp one but sadly no change. I do think its something in the preheat system, but plugs and control module have both been changed. At a loss, as is the garage

Good to know about the pump thank you. Garage couldn’t identify where the noise was coming from. MOT is in a week so will replace pads and discs and go from there

Garage confirmed that all bearings were ok. Sounds like a pump or bearing somewhere

Hi, I have a 62 plate FL2 with 80k miles. Recently, it has started to develop a humming noise form the front of the car. The noise is the same whether under load or coasting. It is not present when stationary. Gradually gets worse when going faster, but no difference to noise when turning left...

Sorry for the late reply. It is a 62 plate GS. It already has the extra earth, but going to upgrade it from 170amp to 240amp.

Hi, the one I purchased isn't available anymore, however it was just a cheap £20 Bluetooth one from Amazon. All you need to do is download the corresponding link on your mobile. I'm still have starting issues. The following has been done in the last 12 months - new battery, new LR fuel filter...

I’ve just attached my own Bluetooth obd reader on and got the below fuel rail pressure on cranking. In addition to the poor start, the humming noise when driving is really quite bad since the injectors were all changed. Never made the noise before. Any ideas? Thanks as always

Cheers Nodge. Garage checked this over last time and didn’t report any issues. Coolant levels have dropped considerably since the injectors were changed randomly

Hi Nodge! Thanks for the reply. Yes the correct plugs were fitted, and at the same time the control module was replaced. Throttle body has been checked, and all was ok. It just had the injectors, not the HP lines - garage never spoke about this. Injectors were coded to the ECM though. I managed...

Thanks for the info Arctic!

Hi guys, looking for some assistance if possible. I’m having start up issues on my 2012 FL2 (78k miles). Always issues when cold, but increasingly happening in warmer temperatures. Only ever the first start of the day though when it’s sat overnight. Either cranks for 3-4seconds then starts, or...

Hi I have two faulty fuel injectors in my FL2 (2013 model with 75k miles), which makes cold starting very difficult when temp is close to freezing. I was planning on replacing all four at once, but wondered if brand new or refurbished is the best. Big price difference, but wondered how long...

Quick update on this. Had the injectors tested an no3 didn’t give a reading. They ran leak back test after and no3 is knackered and no1 not much better. Hopefully replacing them will solve the cold starting issue. Would you suggest replacing all 4 at once or just the two? Conscious the injectors...

Ahh I see. Thanks so much for spending the time to reply ! How do you test for a faulty injector if you can’t do a leak back test? Thank you

Had the issue last few days when the temperature was above 5c so the glow plugs wouldn’t even be on. Will get a leak off kit and test the injectors

Ahh I see. Was hoping to avoid a full new set of injectors. Hoping it could have been seals or o-rings. Would this only really happen with freezing temperatures?