Search results

No noise or vibrations but it was lifted mud tyres loud exhaust and mapped etc... The donut was changed quite a while before the juddering started and was still in good nick. The diff was stripped after I sold it and it was 100% backlash 👍

@landy-dandy I have now sold the car and made the up/down grade to a d3 ... 🤷‍♂️🤦‍♂️ but yes it was sorted before I sold it! It was backlash in the rear diff! No other symptoms but I got hold of a 2nd hand one swapped it over and voila no more jerking. Completely unrelated to anything that I...

Cheers @sierrafery

Thanks

Ok will give it a go 👍

Is there a way to test it before replacing?

Not if done with the buttons. If with the pedal then yes

Yes not the handbrake shoes as they was replaced not long ago as the was contaminated with oil and not holding. Cruise control works all good

I've seen this thanks, looking more for where it originates from our of the main loom as I can't find any wires

I am sure it has always done it since i owned it (4/5 years ish) but I just put it down the DMF the MAP sensor made no difference to the driving of it that i could feel it was only when it was being mapped that we picked up that it wasn't reading correctly. Its the original ECU that was chipped...

Hi all, 1999 Discovery 2 Td5, I have realized that my oil pressure switch is not connected to anything, i cannot find a plug dangling anywhere, does any one have a photo of where it should be routed so that i can go chasing it. Help please. Thanks Matt

Hi all, 1999 Discovery 2 Td5, LOF Solid power spec clutch Empire tuning map. I have got a bad case of what only be described as jerking or kangarooing when I accelerate or let off the accelerator accompanied by a single click when i accelerate or let off. I had this before fitting a Solid...

Apologies for the delay, for some reason Landyzone went into my spam folder so i didnt see any replies. Eu2 10p I have replaced the wastegate actuator, still the same, bypasses the solenoid and voila, problem gone. Do you have a wiring diagram for the sensor, or at least can tell me which wire...

Sorry for the legnthy post. Loosing the will to live with this now. Hi all, currently have a problem with my td5 cutting power at 2800/3000rpm intermittently. It first started at 2500, replaced the wastegate modulator and wiring as it was damaged, no difference. Adjusted the waste gate rod to...

Thanks Stanleysteamer I removed and tested with hose pipe and it only let a dribble through as you would expect... Matt

Hi all, Hopefully someone has had this before and can help. 1999 D2 Td5 I think 10p but for the life of me I can't remember. Temp guage on the dash will not go to 'normal' unless I'm driving on the motorway for approx 5 miles (60-70mph) or I am doing some 'spirited' driving. It raises to just...