Search results

Does anyone know where I could get a 1 full harness. 2 srs harness with it's original ECU. 3abs ECU. have no part numbers in a bit of trouble.

Got the same problem.been trying to do it on mine. How did you wire yours up?

Any chance of a run by how you actually did it.PLEASE👍

Lt230 transfer box. On the bench input and output flanges If you rock the front one way and the back the other way how much play is acceptable.just renewed the centre diff !

Does anyone have a tool lrt-41-005. It's for the input shaft to set the pre load. Any help would be appreciated.£££££.

Does anyone know where to purchase a non collapsing spacer for t/b

Anyone have a r380 suffix j type55a manuel gearbox to fit onto a disco 300tdi for sale

From automatic to Manuel. Does anyone know which model gearbox I should use for this conversion.i know it's a r380. And with having 31inch tyres on should I change the ratio in the t/box.

No gearbox on been renewing rear crank seal. Would it be ok to start and let tick over to check seal ok.dont fancy it leaking.

Swapping automatic box for r380 box.would my transfer box be ok to use or would I need another. If so what t- box would I need what ratio. What has other people used. Cheers.

No not that it won't slide on till that point the pin and bolt holes line up.it sits on the very end of crank can't get it any further.

Here's a one for the experts.n reg import. On changing auto box for Manuel. Renewed rear crank seal.brand new fly wheel holes all line up but a can't get it to fit crank.not slagging any one off so am not after that.but is the fly wheel to be that tight don't fancy damaging it.is it me or is it...

Automatic box changed to Manuel r380 box. Do I need to change gearbox cross member or not.!

Has anyone had problems with putting new fly wheel on. Removed automatic box for Manuel. The tolerance on the crank and center of fly wheel are really close.

Fitting a new rear crank seal disco 300tdi. Does most people only use a gasget.or rtv.or both. Don't want to f up. Cheers

Think I know now.on the automatic's when you take out the box there is a section in-between bolted to the back of the block.dont think it's any good when putting Manuel box in .

I am meaning between the engine and the bell housing. I am replacing with a r380 Manuel.

Changing auto box to Manuel.there is a flat casing on the back of the block that join's the box. Does anyone know if I need to replace it or leave it.because if I have to replace the bell housing surely I would need to replace it. Also what's people's thoughts on the transfer box.should I change...

Going to remove automatic box replace it with Manuel r380 box. Do anyone know if my gearbox cross member would be ok. And would the bell housing need replacing.?

After a lot of problems with the wiring harness. Does anyone know (I know which relays To look at) If I take out the relay's and put a separate fused wire to operate fog and the rear wiper.