Search results

Hi everyone..Update... the vehicle is owned by the cousin of my friend, who does not speak English... The new clutch is made by Valeo...Everything taken apart again....Spigot bearing was mangled..now replaced...the new clutch fork showed it was catching a little...Filed a minimum amount... The...

Hi..almost certain that the clutch plate has been installed the wrong way round... hence not able to select reverse gear will keep you posted. Regards

Hi..all..thanks for your replies.... Kind regards

Hi thanks for reply

Hi again..the clutch has been changed to gether with fork (which was bent)..also slave and master cylinders... On changing gears they catch. When engine not running, without touching the clutch pedal, the gears pass smoothly.. any ideas would be welcome. Kind regards

Many thanks for reply

Hi everyone... could someone kindly let me have the correct flywheel torque specs. Regards

Hi.. thanks for your reply..I was asking for a friend..he tells me that he has steering warning light...I will check again to find out more. perhaps he has got the year wrong. kind regards

Hi everyone... perhaps a stupid question.. can anyone tell me where the power steering module is located. Many thanks in advance

Hi..buy in France at the moment ? I received my letter from the u.k Govt.. yesterday...in the event of a no deal Brexit, health cover will only be guaranteed for 6 months...It seems to be chaos. Regards

Hi..02 sensors and cats....that was the prob with mine Regards

Hi everyone..Would anyone like this unit.. for models without heated seats...I bought this for my car, but it turned out to be the wrong unit... All pixels are working...free to good home. just pay postage from France. Best regards

Hi again.. this may be of use to you. Best wishes

Hi again...also check thermostat housing/pipes..otherwise as above (Datatek) water pump looks favourite...also perhaps rad leak. Kind regards

Hi.. check thoroughly around windscreen washer pumps..the joints can dry and become brittle. Regards

Hi..this may be of help to you. if not too damaged perhaps a repair. Best wishes.

Hi.. whoops....as above....bolts in sequence to 20 Nm...then in sequence turn 90 deg. Hope not too much damage done. Kind regards

Hi..I have read it... Best of luck with your project. Regards

Hi.. did you do a compression test...?..It may also show problem and which side if any is down. Kind regards

Hi.. for me.wheel off, arch liner out and long socket....worked fine. Regards