Search results

Right then, after seeing our mate @Datatek last Sunday I am now the owner of a zfhp24 box. After comparing a couple of things the input shaft and oil pump drive are different lengths. Now the question... Can both the input shaft and oil pump shaft be taken from zfhp22 and transplanted into...

Right then, my new in 2022 blueprint front left wheel bearing has play in it after a full new assembly was fitted😵‍💫 So, as I have a recent hub and carrier unit. I'm no going to go down the full replacement route again for just two years and I'm asking for any knowledge or experience of the...

Happy new year to you all and may it be a productive one😎👍 Oops, sorry this may have been better in the tratter section🤭🤪😝

So I had a "market not set" warning on the car this morning while going to rescue my lad and his clutch problem scooter at 1.30am.... I had turned the alarm off the other day and then realized the indicators wouldn't flash on lock and unlock. Now, the immobilizer and eka are turned off and for...

As above please guys. Reviews, good bad any pictures or model numbers. Length of time you've had them and any issues with installing the kit into the car or running issues you got over or just dealt with. Thanks in pants in advance 😜

So after 255.000mls my rocker seal is leaking.. Pfff OK, removed, stripped out completely all it's internals and got it all clean. There was no gunk in there at all👌result and proof of regular oil changes.... Except the seal I bought ( god funking forgive me for making this mistake).. Yes, you...

Happy easter peeps👌😎👍

Is it bolted or riveted? 🤔

Hevac bolloxed?? Blend motor open circuit to positive. The motor works including a second motor wired up. The potentiometer no feed back Checked and works after resolder. I've fitted second blend unit and I have the same motor short issue .. I really don't want to pull the flipping centre...

All the best to all the best☺️🥳

So, last night at 6°, my fip was flashing the engine light on and off briefly while lifting off from the throttle after about 20mins of driving. I remember it doing this at the start of the year at lower temps also. My question, if the fuel heater on top of the fuel filter fails and only having...

Hmmm, ferrodo hand brake shoes... Just a word in the ear. The ferrodo kit for the disco 3/4 handbrake, the kit is of poor quality I found doing my last job on a clients car. The clips that hold the shoe to the backing plate were the first issue as when they are compressed to fit around the pin...

So.... Plenty of new parts for the aircon system on my lads 38'. Our resident tech master has checked and tested the hevac. We checked the pressure in the system and was off the gauge!!!! Personally I have no experience with aircon systems and I'm going to ask those who have more than me this...

As said above, if you have any mods that make a difference to handling, upgrade or other ? A provisional repair that turned out better than the original design? Spill the beans and share the wine gums 😊

Here's one for you guys as a checkover job. The second battery only charging at 6.12v.. After looking over the charging terminals on the unit close to the second battery housing. the top one was burnt and the plastic capped brass nut was deformed. The contact surface was also charred, the...

Jeez, so one of the little sliders responsible for lifting the rear of the sunroof glass has snapped inside the sunroof cassette. Although maintained and after 23yrs it has popped and left the glass dropped at one corner. Thankfully I noticed the noise on the motorway and didn't pop the glass...

Well I never, this new format looks smart🤟

Anyone had a reply from admin? I've sent two pms about the photo upload issue and had no reply:( Is this personal :p

Anybody got window deflectors on their bus? How have they faired? Make? Easy to fit and solid? :D

Morning guys, anybody heard from our @RangeRoller dt recently? I've sent a pm but no response? :eek: