Search results

No problem if it starts working again and I imagine once broke it'll just stay open. Not heard of one going closed.

The pictures from @Arctic2 as so helpful, thanks for putting in the time and effort

Same here, I can't leave it overnight with the handbrake on or it sticks.

The handbrake lever, bottom of pic 4, needs to be free to enable the handbrake to release. It's a little lever.

Probably the radio itself.

Maybe some help, an e4 error on a rover is inside temp sensor issue. Where it is I don't know. But I looked for e4 air con fault rover. If you can find some images it may be the same system.

If using a heat gun, and the car is scrap, warm the surrounding metal rather than the rubber.

Single spot light on the rear will stop that

The bleed screw is on a loose bit of pipe down the UK passenger side. The master cylinder is tiny and be careful not to drop any of the black insulation in it. I use a syringe to slowly fill it, or you could suck some of the old fluid out first to change it.

Shop around for price but I have recently found Halfords cheaper if you either use trade card or join their motoring club.

Try bleeding the clutch. Mine goes like that every 6 months or so and air in the system is common, especially if the clutch or master cylinder has been changed in its life.

The lights dimming indicates a drain on the battery, so starter is trying to turn and something stopping it. That could just be a failed battery. Standard car batteries don't like being fully discharged.

On the alternator there should be 2 connections. A big wire to a bolt terminal, power to the battery so don't earth it. And a connection with 2 or 3 wires. Confirm both are connected.

It may have been disconnected if the gearbox has been removed, and forgotten to reconnect. I assume it's only needed for hill descent control

No need to lower anything, apart from maybe the exhaust. Plan how you are going to run it as both ends are a pain. Get some more clips, maybe even at the rear leave old pipe in to clip to. The bends to the abs pump are tight. You'll probably need diagnostic software to run the abs pump while...

Bigpluke was on the forum for 11 days in 2016! Post a new thread in freelander section

I put the rear axle stands on the subframe as the jacking point is near to the corner that tends to turn into dust. I did drive it onto ramps, then jack the rear up to put on axle stands. Never doing it again as when jacking it moved back slightly onto the ramp, then as I lifted the back off...

Yes to swapping the control unit.

A decent o2 sensor socket is a must. It has a cut out for the cable. Maybe a short breaker bar.

Depending on your reason to remove glow plugs, the M47 engine will start with just 3 glow plugs. May get a bit f white smoke until fully firing.