Search results

Just a side question, my nanocm has stopped working properly, I want install firmware but it asks for a numeric code. Where can I find that code

Just a side question, my nanocm has stopped working properly, I want install firmware but it asks for a numeric code. Where can I find that code?

Where are the brake switches to be found? Near the pedal presumably?

I can tick off the ABS sensors as good, The bulb is new I should begin looking at a wiring fault, the wiring all looks tip top though, this truck has been kept well.

Just took it for a spin and still have the ABS TC lights on! I had my nanocom going? not sure what to make of it? brakes feel good.

New bulb fitted, brakes bled, ABS-TC lights still on! WABCO D OUTPUT SETTINGS?

Thank you Mark

Yes, yes, I will go through the decompression procedure before removing the accumulater. Thank you again guys

Thank you both Time saved I shall order a quality replacement today! Once again Datatek, you have saved the day, kudos!

I only got the nanocom yesterday and have not a clue what to make of the data!

One and it runs for 3 secs

To good to be true, but the sensors look okay, and no faults reported

To get this the The ECU should be okay to produce this data right?

My P38 has the same issue, ABS n TC lights on! After checking with my nanocom I get no faults The same voltage form all sensors:

Hi Bob I am new to this so if I am coming across as a bit thick it’s probably because I am. I use a thermometer with a red dot and point it at various places: Low down on the engine block gets to 45-50 max, after an hour ticking over. The metal intakes to the radiator are 24 one side and 30 odd...

But data has mentioned the thermostat as the possible culprit so that first

Thanks, that is what I needed. I will flush the cooling system while I’m at it! Ta very glad 😃