Search results

HI, does anybody have indepth knowledge of seat boxs? Is the 90/110 seatbox same as series? can you fit a 90/110 under seat box to a series seat box? or do i use plywood as before? Thanks

Hi, does anyone have a steering wheel with horn push? I would like the one with wire spokes. many thanks for looking at my advert.

HI THE work shop manual is pretty unhelpful- the seals from paddocks are almost useless- and need a redesign. the lips are not big enough to seat and the rest of them is too small to fill the gap. Much hammering with a blunt bolster. I've walked away for a while. Do you know anyone who might...

I fit a galvanised steel bar 30 x 10 across the chassis inside the first floor support- this is bolted to the chassis each side. also i weld 25 x 3 straps on the upstand strengthening plates(where seat belt stalks fit) to the chassis....

Hallo At 4 pm a group of chaps will help put the roof back on my 2A 109 SW. How do you get the Bluddy seals in place?

I have bought the diesel timing kit from ebay - now i am staring at it.....

I think it is the seal where the DIP fits to the case.

hi has anyone in the midlands got any glass for the sliding side windows in a series 2-3 station wagon? Mine have got welding/cutting flash on them........ offer cash and or Cider

The whole saga of this item is going to stop me sleeping....

Thanks- still not sure how confident i am with this....

Doom and Gloom- the short lived joy at removing the crank sprocket with a home made puller has evaporated...

Many thanks- this sounds like a very worn engine that i have bought.

Hallo. after being left overnight I was curious to see diesel over the floor and on the inside of the timing belt case. it was dry yesterday- from the pooling it can only entered from behind the camshaft sprocket. Is this likely? it had not happened in the last week or so that we had cover off-...

Many thanks- we will proceed carefully.

I notice with horror that the haynes manual says use new main bearing cap bolts and big end nuts. is this really necessary?

just started filling the surface imperfections - as I kid myself - the welding has taken one 5kg roll of wire and 3 big gas cylinders. body to start next........

having just spent 3 weeks rebuilding a bulkhead I can state that next time- either a new bulkhead or vent panel section- it has been hard to do.

HI I Am new to this engine and i cannot understand the books. 2 questions: if the engine has no flywheel fitted how to i time it to change the cam belt- there are marks on the cam pulley and secondly; Does this look like oil from the crank front oil seal which should be replaced? thanks.

I had 2 of these riveters- superb. Until my mate took it apart to see how it worked---- now I have one.

many thanks- most useful