Search results

Just been to check and it has gone down about 15mm, started up to turn it round and suspension went down, I think I must have done something wrong when setting it to coils as it stayed up last night when set to air.Is it just a case of changing the setting from air to coil, or should I have done...

Nanocom shows both sides to be different, but its showing 0 volts so a fault somewhere with sensor/wire. Anyway need to use Discovery on monday so going to look again after trip to town. Thanks Richard.

Well the bags are still inflated today, allthough a bit high, went in to settings to lower a bit. Then got called away for 10 mins and it was down again, I think I heard a click as I walked away, so could the problem be a solenoid sticking?. Raised it again and put it into coils setting. New...

Thanks for that, got it to go up in utility, took a while but got there, I have found the right sensor shows 5volts and the left 0 volts. Is that my problem?, be interesting to see if still up in the morning. Yellow fault light still on. Brian47, will check in the morning, doors were closed, I...

As I stated I lifted the body up ,but it never went up, the compressor does not run so it cant go up. I did not adjust anything just powered the comp from Nanocom.I cant see how new bags when they arrive will sort the comp not running, I suppose both ride height sensors could have packed up...

Ok, so got Nanocom conected, no faults shown, turned compressor on and it cycled on and off I presume thats correct. Vehicle did not rise , jacked it up a bit still did not rise. Not got new bags yet, delivery takes a while to here. I noticed a difference in actual height settings of the height...

Thanks will do.

Looking at a 4.0 HSE on LPG, are there any issues with removing the LPG system as I dont do a high milage and no LPG stations near me, eg 200 miles away?.

I mentioned the wind situation as I thought the P38 did keep levelling if one side dropped. Anyway I have a Nanocom, but never used it yet, to be honest I am not sure how to use it.

I might invest in the air bags to see if they are the problem, but that does not explain why the compressor is not running.

Hi, went to move Discovery yesterday and the rear was on the bump stops, it was very windy here tuesday, could that have caused the suspension to keep leveling? and drop ,or does it only change when ignition is on?. Got it to rise today by pressing off road hight switch, it then levelled itself...

Looked at the chip, if they are normally soldered in this one has not been. The numbers on it are as follows 1 037 351 254 0 281 001 677 Does that make any sense to anyone? As I said not going to touch anything as it is running ok at the moment, just interested to know what it is.

I dont believe in tempting fate so will leave it alone and hope it keeps going with no problems, I might try to find the last but one owner to see if it has been chipped and with what.

I will have a look in the morning, I will only look because it is running fine at the moment. I will also get the numbers of the chip in glove box.

OK so which box of tricks do I look in to find the chip ? also would a chip make the gearbox jump down two gears?.

I dont want to race about just be able to move at a reasonable speed with trailer in tow. Unfortunately due to where I live I dont have any chance to test the P 38 on a long run, only when I want to do the towing. I think I will put the manual P 38 back on the road because when I used the...

As title says on a slight incline/hill the vehicle sets off ok but when starting to climb the revs go up but the vehicle does not increase in speed. But if I kick it down it changes down and pulls off and then changes up, it seems ok on the flat The oil level was a bit low but no change after...

Last year I had overheating problems with the P38, the radiator and water pump were replaced and have not found any engine problems as a result. I have a manual P38 that has been off the road for two years. it needs a clutch and brake discs maybe I should put that back on the road. Is the...

Has anyone got any experience of towing loads of about three tons,this will only be once or twice a year but journeys of around 500 miles. I know its not the most Ideal tow vehicle but at the moment needs must. I have considered chipping for more torque, but I am not sure if it will give what I...

Yes It has been converted to 12v, I can see a rotary switch above the gear levers in the dash board and It has a full canvas but apart from that I cant see anything out of the ordinary. It will be about three weeks before I see It so will get to check what It has still fitted then.