Search results

Something still not right! After complete rebuild of ABS System , sensors and abs rings there is something thhe system is not happy with . Iget the three amigos , clear down faults turn the engine and system down , turn on again fine . Then go back in twenty minutes and everything at fault...

Hmm. yeah , speaking to the manufacturer he has had good results , so will see, thanks.

What I should have said is The other side is needing a new boot at the same time as the ring. The end of the shaft where the seat is for the ring has lost about 1/2 mm to corrosion , so no chance of distortion, quite the opposite I'm afraid but not as bad as the rears, it was touch an go whether...

Shaft out , turned 180 and no bother , would have to buy a rubber boot and cv joint? , lol, trying to watch pennies! All cleaned up and painted , ready for new ring.

The rings are bought from UK Parts and due the corrosion ton the end of the ring seat they come with a bearing fit fluid and with that its better out in order to clean up the shaft and allow the ring to sit on the ledge vertically and set in its proper position, I have done the rears this way...

Ok any good tips to get this driveshaft to release it out of the diff , despite using bars , hammer etc. please

Reading with great interest here as I am replacing the ABS rings , Did I miss the answer to the question of , how do I pull the driveshaft through the hub , to finish the job please.

Many thanks for your reply , its good to hear other thoughts when your going round in circles. I have two diagnostics it happens so it does help and between them they both show the faults albeit in different ways , so definitely the car . What its telling me I think is because it seems to be...

Came back to my Steed on Tuesday after leaving it with no faults and tried live values while all faults gone and it refused to show them . Sas I say started it today and all lights on again. Jumped out after going for a small run and switched off , closed the door in disgust went back in and...

This machine is all over the place as far as finding faults, its very frustrating , however I have had some cautious progress, after some testing of values at the ABS plug and at the sensor plugs , to find why I wasnt getting a signal according to the diagnostics. I then swapped the front...

Ok chickened out on driving with wheels in the air as I was wary of what the suspension might do .Just to add , I forgot to say that I got no live readings from live values on speed sensors , weird or not , perhaps the ecus are not speaking to each other as seen in the above picture. I am...

Many thanks , will do , I am on other forums and with long threads , so getting a bit long winded this problem , it’s quite a procedure raising this old fella , to get the wheels off the ground and since the suspension is locked at normal height , it’s quite a way up! Hopefully I can drive the...

Well it is Ill try that maybe tonight, didnt know it was there. My other diagnostic having removed and cleaned , which incidentally are are new had picked a little brown rust since assembly only dust seem to be clear of fault (ContyscanVdo) , but still canbus error and ebv fault.. Will the live...

Battery Good [/IMG]

OOPS Sorry Range Rover L322 . 2004 TD6

Recently replaced all sensors for the ABS system. I replaced because they showed faulty and all sorts of Air susp. /HDC errors started to infect the system. Unfortunately the rings at the rear were corroded beyond help as my replacement sensors including new fronts were not resolving all the...

Ok , after dismantling the gearcover and part of the console as I was sure the fault lay there the last time this happened, I took it to be a loose connection as It started after tweeking them. There were no specific fault codes so a bit baffled and no one has revealed where the starter relay...

Yeah quite a few!