Search results

OKdefinitely something to think about, thank you, so I will give it a go. I will check the pins for lives when the switch is activated .So what your saying is BCU is second in line to the circuit only to activated a timed circuit?

Well that is interesting, so if this put in place of standard relay for H/S circuit this would overide the Bcu ?

Yes that would be correct , I got the vehicle at least 7 yrs ago and had fitted a heated screen, wired in the scuttle and relays fitted and fuses. The only thing I have done is fit a switch on the dash , LR one . I use Contetech for a diagnostic , fairly comprehensive but doesn't enable the BCU...

Hi Neil, the Landy zone IR?

Is there anyone in the area of Morayshire/ Grampian who had the Nanocom disgnostic tool as I believe it may enable my.front screen through the BCU.

No probs, many thanks anyway, all back together and still working!

OK , thanks for your help out there, I guess you must have missed my success at the start of my last thread , especially if you picked up on my heated screen issue. I will have to put a plea out there if anyone near has Nanocom .

BINGO , Success, thanks for pointing me in the right direction everyone. The system needed activated by the ignition/engine on , then when I switched off all was fine , interior light energised! Next resolve is to get the BCU energised to accept my heated window, my diagnostic will not enable...

Aha! Ok if your seeing the small screwdriver this is the male side of connector opposite to PU . This is where I get contiunity to BCU.

Ok I have tried to study this, if I make a temporary connection from the back of the grey plug on the male side the interior does indeed come on.I can also get continuity to same pu wire into Bcu (black box?) I get the feeling its lost through to the otherside , unless I have activate the...

Many Thanks , I will get on the case now, fingers crossed, I have already located these plugs and cleaned up any corrosion , even got one wire separated from location , managed to clean and bare the end put some solder on it and pushed it back in , tested it end for end on the plug and seems ok...

Every thing back in and working , managed to slide a pipe into each end and used epoxy to sela.

Amazing response, thanks , yes they have worked till recently, manually ok just now , but not with key fob or door opening . I have had to weld the scuttle panel recently as the bonnet hinge mounts were rotted through. There was a lot of water and consequently , still going through a lot of...

Can someone help out here ,I am trying to download a wiring diagram for my disco td5 2001. The Rave cd which I am in , lists 2000MY -2nd Edition LHD is that left hand drive and up to that year 2000? Or is the other option 2003 MY (WHAT EVER MY IS ), excuse my ignorance!- 2nd edition NAS My...

No sorry , that's the tank breather, it's the connector with the pipe that has a curl on it , hence the pigs tail . As I say the round connector in the very first pic shows that.

Hi it's the round mounting that fits the tank , it has a plastic horsetail on it which is snapped off it.

Thanks for your help , but I've seen hat diagram and the part is not listed separately.

I am having some difficulty in tracing a filler pipe breather tank connection. I t doesn't seem possible to get a hold on this connection that sits on the top of the tank. The hose tail attached to the connector , has snapped when I dropped the tank down to weld the chassis. Perhaps there is a...

Please anyone !

Just picked up your interesting thread, I have exact same problem both sides on my Disco 2 , was there any good reference points to get the bracket in the right place please. Im dreading this , asyou pointed out so any tips are invaluable. If anyone reads this , perhaps they know of a repair...