Search results

my next question is how come that a starter and ring are damaged already within such a short period .They were new and were replaced by a experienced land rover mechanic.

we just checked the starter ring all over but the ring is too far gone.even when the start of the turning is ok it slips out half way.So I ll have to do the renewal all over again.

p38 gems 1994 4.6hse Within 6000km the ring gear and starter are damaged again.It starts but often with crushing noise. I hoped it would be better with a brand new starter .....but .the gear has at the dead point too much damage. I do not have time coming months to change the gear so my...

problem solved. checked all wires , sensors cleaned everything starts perfect when warm

ok thanks enough look at this weekend

engine is perfect

The starting is only bad after restarting within 2 or three minutes when the enginehas been at max temperature. After 5 -7 minutes the starting is ok and when the engine is about 30 celcius it still starts ok. The bad starting sounds like misfiring with a wrong ignition timing

I have no nanocom I ll have to solve it without

P38 1994 4.6hse had bad start when warm .replaced the crank sensor .problem still the same .Checked all the wiring up to the ecu .What could i do next

my p38 4.6hse 1994 lpg prins injektion starts very bad when half warm.(petrol) Cold start is good (petrol) When maximum temperature it stars automaticly on lpg so no problem.So it could be the crakshaft sensor. I tested it by removing it and then starting with cold engine .....no start. So the...

replaced the starter and starter ring 2 years ago about 12 k km ago

I tried freeze spray, no result.ormal Is it true that an abnormal sound of starter can be caused bij a faulty crank sensor .I changed the starter and ring on the flywheel two years ago. When I start with cold engine I hear the starter only a bit at the end.When I start warm it seems as if the...

p38 4.6 prince multipoint lpg 1994 After replacing becm (earlier thread) engine starts fine on petrol when cold en goes smoothly into lpg modus. When warm it does not start on petrol until the engine cooled down fully. I changed the crank sensor last year.I read that the car will start...

indeed

you were right the 11 fuse was still there it shifts ok and everything works. I still can t find out why they changed the becm maybe during a long testride this weekend I ll find out after my rover p6 this is the worst car I ever had...........almost no better car to drive in so I ll keep on...

I build in the old becm again which came with the car which was replaced what I mentioned earlier.This one had a code. The car ulocked then I used sync mate and voila the car started.Everything worked ok Only on the display came transmission neutral, but the gearbox worked fine. After 6 miles it...

I have the car for a year now. The dealer can t remember what the cause for resetting the becm was he could only see he shipped and build in the new becm. The whole problem started after washing my car with lots of water , then I had to replace the rh doorlatch and the car got confused.Then all...

Is it normal(what is normal for a p38) after 1,5 years and a 300 euro reprogramming of the becm everything starts all over again ha ha ha

In an earlier thread a had a becm lockout .I had no keycode and tried syncmate. I found the previous owner and he told me becm immobiliser was disabled .I phoned his garage and they told me the becm was send to a specialist to disable the becem. Well the display asks now for a keycode and...

Ok I know what to do. Is it true that a pam number w39 on the becm does correspond with a late 94 p38 like a have. I am not sure a new becm was put in I just found in de back of the car a becm ignition key and speedometer display housing I found that late 94 p38 have much lower numbers.but the...