Search results

Forgot to mention a warning on the dash say's catalyst overheat

Look at these.

Found an air leak on the o/s/rear suspension pipe. Fitted a new pipe then started the engine to see if it lifted the body. It did not lift at all so I connected the nanocom to see if there where any faults. Now the engine will not start. I must have messed up the immobilizer by pressing the...

Hi All, Went to the shops yesterday and it was like off roading, It was as though there was no suspension on it, just rubber wheels. The warning on the dash came on with EAS Failure. I put the Nanocom on the car and there was no readings on the height readouts. Nanocom just locks up when on EAS...

Fitted the new sensor and all warnings are gone. No faults showing. Thanks for all your help. Luckily it came out nice and easy.

Diagnostics is now saying the o/s/front sensor is faulty. I have ordered one today so I have just got to wait now.

There are no fault codes anywhere and the voltage is fluctuating between 1.93 and 2.12. I have checked the connection and it is ok.

Abs warning light comes on also now. The only fault showing on Nanocom is front right sensor is lower voltage than the other three. Do I need a new one? or will my sledge hammer fix it?

Range Rover 2001 P38 2.5td. I have noticed the car is not as smooth as normal, It feels like transmission, not a continuous rumble but more like a tyre with a nail in it. I have now got the traction control light appear on the dash. I 'm not sure if it is just me but the brakes and steering seem...

Came out of the doctors this afternoon and the gear selector would not go into any gear. It felt as though there was no pressure on the release button. The only way I could get it in to gear was a strong push. Any Ideas.

Hi All, My air con condenser has developed a small leak. I have tried all the usual land rover spares stockists but none can find the one that is fitted to my 2001 2.5d. They say it is discontinued. I can find the earlier one but it is too big. Any Ideas as to where I can get one or get this...

I did try an extension lead. But it would not work properly. I will test all the pins to see if they match.

I would have done but i'm sure I read from Nanocom you must connect to the unit first and not the socket.

Ok, Thats good enough for me. It's just that I suffer with a bad back and sometimes I can't get to the plug easy. Looks like a job for the wife. While i'm here should my BECM be Locked or Unlocked ?.

Is it ok to leave the nanocom continually connected or do you have to unplug when finish using

I will try again tomorrow. Thanks

Tried to adjust using Hevac speed control. but it doesn't show the readings, it says unable to communicate. The thing is it's saying there are no faults in the Hevac.

I sure will ,Thank You.

"Wow", you have done your homework, great thank you. On my nanocom it says left side blower 0 % and the right side blower is 232%. What now ?.

Many Thanks. It does say right hand blend motor, what would cause that ?.