Search results

490 Miles to far for me?? 😜😂🤣 Kev

When you have cleared the area! You should be able to see where you need to go! As for cleaning the rot! Take it back to clean steel? (Your looking at minimum 10mm clean steel for your plate/patch) Kev

Looks brilliant mate👍😁 And the same places as mine😜 Good work. Kev

I replied to one! With pics attached Kev

Always a good idea! Should not take long! Just back sure its done under cover or a good weekend of no rain? And a second person with torch!! Kev NB: torch also good for footwell!!

Last year!! Obviously was not seen for 2023 MoT!! But was for last one!! Like must of us! We say 'I will do it later?!?!?!' So! I did not get round to it! Until MoT! And got all of it done in one 😁 and other bits!! Advisory for just 2 points!! One was done when handed the car after MoT (rear...

Some of the pics did not come through!! Not jpg files 😡 Kev

Had both sides done! Wheel arches and footwells?!? Also anything that need to be down whilst in the garage!! (Good that I was also there to help with mine and other cars 😁) I'm still learning welding!! But all the plates/patches were done by me! Some pics to follow 🤣😅 Kev

How old is your car!! If the same as mine 25yrs!! 'TRY' and save as much as you can! I lost about 30-35%! And is like 'Rocking Horse 💩' to find!! There is industrial foam that may work! (Have not got that far yet) but it will need to be heat resistant!!?? Driver side - manifold?? Passenger side...

Have a look at bulkhead via the footwell!! Or look at the bulkhead from the bonnet to see!! I have just had to do some welding around that area on both sides! Kev

There is a thread on here! Use the search engine?? Kev

If you have a hole there already? And yours does not fit? You will have to make one? Take a look at the attached link! May give you some ideas! http://www.discovery2.co.uk/navigation.html Kev

I think your going to get 3 choices to your question?? 1. Yes 2. No 3. Your choice 😅🤣😂 Kev

Cam journal can be repaired! But the cost of sending to a specialist ìf your unable to remove the head yourself?? 💷💷💷 Kev

Best wait for @sierrafery electrical wizard to reply! Also pop over to 'Introduce yourself' to let us know what, where and all that! Does wonders when you have problems later on (Landrover owners 🤔) Kev

Yes! Was looking at replacing mine because of rust at the bottom of the door! Picked up! Took home! Did not need it after all, sold on! £10 Profit 😜 Just make sure all sharp bits and glass are covered and not going to move around? Kev

All the above are good! I also went looking for replacement? At the time I could not find a company! So I stripped it out and covered it with paint

See if this helps?? Also! see if it has been damaged by moisture? Kev

I had to make a patch under the Servo with sealant?? (Temporarily) to stop water getting in to the footwell!! But now in garage being sealed by weld! Plus the other bits that need it! (Wheel arches NS/OS - Footwell Bulkhead) but while preparing for welding!! Have see previous weld attempts🤔😫...

They need to ask why?? Crime in the area is low! (See Attached) Kev