Search results

Not contaminated, just been stood for a while - could well be rust on the surface, seized pistons or the servo will check later today thanks!

So removed the wiper and nothing is moving from the exterior point of the land rover. I haven't looked inside under the plastic cover but believed this to be rusted in place, how do you free this up?

Hi all, Disco 1 200tdi rear wiper motor can hear turning spinning or doing something but the wiper is not moving, guessing the pinion is seized any advice on how to fix this. Thanks!

Thanks all - I'll check the servo vacuum first then update this thread. Haven't changed the pads or discs recently, but thought the build-up for rust etc would run off after some brake tests.

Hi all, Working on the brakes recently on the disco, not driven for 18 months or so. Yesterday after bleeding and changing some of the lines went for a careful drive, on pressing the brake pedal this felt hard, but not the usual soft to hard. The pedal effectively presses the calipers in but...

Thanks guys, going to clean this up!

Hi all, Carrying out a service on the 200tdi and noticed a filter to the rear of the vehicle underneath, does anyone know what this is? Thanks

Hi all, Yet another thread here. First of all thoughts on replacing discovery 1 200tdi discs, they have been sat for around 18 months, would a couple of careful drives see them back to normal? Replacing the discs on this look more involved than first thought, it's not a standard replacement...

Discool, the issue was the third nipple, i thought you were joking about this! Tucked around the back, bled through working like a dream, thanks alot!

Mega useful and thanks for taking the time to upload this Discool. From the diagram, I can trace back from the MC to the primary or secondary! Thanks again.

That's it, thanks for sharing Discool.

Hi Europa that part I think is to the chassis not the end caps: https://www.johncraddockltd.co.uk/ntc5106-bracket-bumper-to-chassis-rear-discovery-1.html Nevertheless, I think I've found it, expensive! https://www.ebay.co.uk/itm/280651998921?epid=656193290&hash=item415829a6c9:g:VCcAAMXQoiJRf5kZ

Great, I do have the disco manual now you mention it and will check. Thanks!

Cheers Europa, but I have no way of attaching them to the bumper, I guess I'm missing a bracket for the rear as similar to your post above about the fronts.

Discool, thanks for taking the time to reply. No I didn't know all of this information, you mention third nipple is that right? Well as I installed new copper lines I might have crossed them over, should that matter? Thanks

Hi All, After changing the brake lines on the disco, the front left, passenger, nearside caliper is bleeding but only comes out as a trickle when using the gunson ezi-bleed. The upper rear nipple on the caliper bleeds as expected with a good flow but the front nipple only blobs out. Is this...

Europa, answering everything for me at the moment thanks! Sorry I didn't put in the original post, it's for the rear bumper, any thoughts? Thanks

bump it up

no response, someone must have done it?!

Hi guys, I'm in the process of fitting a 300tdi bumper to my 200tdi as the old one is rusted. The end caps from the 200tdi fit but there is no where to mount the sides onto the body of the disco, is there some kind of bracket missing? Or should I need to purchase 300tdi end caps? Thanks,