Search results

Did the hevac get checked mike??

I assume they use the ends off the old pipe and replace the rubber hose?

Evening, Can any one tell me the part number for the high pressure hose / pipe that runs from the pump to the condensor? its the smaller one of the 2 and it has somehow developed a pin hole in the rubber bit leaking green aircon fluid etc. Why has this gone? is it age? system was regassed last...

yes door card removed in referring to the plastic clips on the ends of the rods in the latch area!!

Bump.

Hello peeps! The cable has snapped behind the pull handle I have ordered a new one however is there enough slack on the latch if I unbolt it to access the other end to fit the crooked end of the new cable will I need any clips that break etc ?? Or am I worried unduly? Thx nick

That pipe goes from that tee joint to the brake pedal dump switch just above the brake pedal the switch releases the vaccumm produced by the pump thus stopping the cruise Look in the area below the tee or bulkead as the pipes can perish and drop off or replace the pipe from the tee to the...

radiator £200 rf reciever £160 locking wheel nuts set £85 belt and tensioner £85 plugs £24 switch pack £120 Battery £60 hoses £45 cruise ECU £45 steering cassette £150 inverter £30 Foot switch for cruise £20 boot liner £80 Mudflaps £80 Mats £80 track rods ball joints and ARB links £450 Blend...

Hi Folks, I have noticed in the cold weather that my air con pump seems reluctant to kick in when selected on hte a/c hevac panel, ie lo is selected on heat and pump light off. Is this beacause the interior sensor is seeing its too cold in the cab? or is it because the exterior sensor is seeing...

Thanks for all the messages I fitted a second hand unit collected from Hi Range Ltd Near Burton on Trent today have fitted it and all works ok now. I want to try and find where the old one has faulted so may be able to locate the offending component. Could it be due to the condensation within...

the fuse 1 feeds radio memory and trip computer supply so as these are ok i think its got to be the switches!!

Hi Team, I seem to have a weird issue with p38 1997 SE windows, sunroof and mirrors. I got into the car today and basically nothing on the centre switch panel would work. If I remove fuse 1 which feeds power to the centre switch pack outstation then on trying again the windows work and work...

do you have the felt cover under the bonnet? I do not need the clips but just the felt cover!!

Had the flaps calibrated today using autologic and there is slight improvement however it does still blow from footwell when face or screen vents are selected. It must be an anomily of that particular heater box so as it works ok ish I will leave it as is unless someone has any suggestions. Nick.

I've noticed today the blower seems to send air to the footwell all the time ie if I select face vent it moves to the face vent and blows out the face vent leaving the footwell but footwell seems to still get some blow same with the screen setting too which shuts off face and moves to screen but...

Report..... Following replacing the ecu no problems observed with the cruise control so the ecu was at fault.

2621 is a red unit for petrol V8

Well today I have been to a breakers and got a replacemnet cruise ECU amr1173 and inverter together on the bracket, replaced it and my cruise seems to work ok now. It will be interesting to see how long and if it works at every time, temp etc! will post findings here.

There is a site, which is called Just Answers, and I paid £50 for an opinion, which I didnt object to at all, as I needed 'the opinion' of someone legally trained, and that word opinion is magic, it avoids litigation...lol yes however you have said legally trained and some contributors on here...

Ive just replaced the power sounder on mine does yours siren if the battery is disconnected? I wonder if the settings need checking in the BECM?