Search results

Hi was spot on aftermarket egr blank was 5mm too short so wasn’t clamping properly had to take the egr blank off clamp it then re fit egr with a pull and bar must of been cheap aftermarket part to be short I’ll advise anyone to not go that way thanks a lot for help

Hi thanks for reply yours look a proper job not like this bodge ,it’s definitely not blanked off so I need to do this sooner rather than later yer I have no idea how this works that’s why I’m here thanks

Hi This was already done when bought car ,,was a lot to do on her I’m going through things one at a time this is something else what’s popped up it’s just been through mot and passed , should be there be a blanking plate in between the two pipes where clamp is too hold them together there not...

Hi thanks for the replies here’s some more pics I’ve took clamp back off and re fitted still smoke coming out should one pipe actually fit in side the other or just butt up to it because mines not quite long enough to fit inside by a few mill

Hi peeps I decided too do my injectors other day which all went fine until put all back together ,I’m getting smoke come up from where the egr was the clamp is leaking should there be a blocking plate in between the two pipes please see pic not best pic try get another didn’t hear anything fall...

Hi all back again :( on the verge of giving up seems like one thing after another , just lost all power steering fluid from pipe at back of engine below brake master cylinder right up against bulkhead two spanner job too tighten up anyway managed to do that after spanner rash galore and 4hrs of...

Hi grumpy gel Suppose mistakes happen just hope none are dangerous enough to cause accidents, ah NZ love to visit one day looks beautiful

Hi alibro Thanks for your reply It’s a freelander 1 sent me two different size drop links wondered if they sent me front and rear instead of just front

Hi peeps thanks so much with your previous help use have given wouldn’t have mot without u guys , I bought a set of anti roll bar drip links for front I changed one for mot all good then I thought change other one had a bit more time on my hands to find its 25mm longer than other bar new and old...

Hi people hope your well after last post I managed to do brakes , I noticed cv boots had split inner and outer ordered drive shaft came today was a nightmare removing old one everything was seized in place cursed just a little no a lot actually I’m having just as much trouble getting new one to...

Hi thanks for all the replies it was the slide pins on both top sides seized in never seen this before learning as I go grateful too all

Telbr7 said: Hi peeps just bought a cheap landover freelander 1 I bought some new brake pads from Halfords and seem very tight with piston pushed right back I’ll attach pic of box what they gave me if u knowledgeable people could tell me if they are the right ones couldn’t get back to shop ...

Thanks for the welcome I will post too freelancer page thanks

Hi peeps just bought a cheap landover freelander 1 I bought some new brake pads from Halfords and seem very tight with piston pushed right back I’ll attach pic of box what they gave me if u knowledgeable people could tell me if they are the right ones couldn’t get back to shop , useless in there...