Search results

hello Most of my wires on my series 3 are ether broken or missing. i was wondering how hard is it to make a harness and if anyone has a good design/layout of the chassis and engine harness that i could follow when making one. cheers

hi I have seen lots of place that sell rear half chassis. but i was wondering is there any place that sell a front half chassis.

Your clocks/dash look good. they look like they are new out of the box. i hope i can restore my ones so they look like yours

well what is a good price for one that can be used for sand blasting.

Hi All I was wondering if anyone know the best place to buy a cheap but still ok air compressor. I dont mind if it second hand, i want one so i can do some sand blasting of some of my landy parts. Or best place to hire or some one who is willing to led one. Cheers

cheers i will try that. hopefuly that will work.

Hi ya all I need some help i have brought an engine. i started to strip it down to clean it up. I ve got to the bit of taking the timing gear cover off but i can not get the starter dog off because it just turns the whole shaft. :( How can i stop the engine from turning so i can get the starter...

So its not possiable. i will just use my dad L200 then. that will be able to handle it

ended

cheers 90truckcab will have to ring them up tomorrow. Is there anywhere else on the web that anyone know of? Cheers

Hi I am looking for spare springs for my Lucas M418G Part number 601754. Does anyone have any spare laying around or know where that i can buy some from? cheers

i was hitting them directly and they did not break

I had this problem they would not move at all. Then i got the old lump hammer:D out and just keep hitting it all round the edge, also hit on the front abit to see if it would brake what was holding it. after about 5 - 10 min they came off. turned out the brakes where stuck on. hope this helps

will they also get rust off as well. cheers for the info.

hi ya I wanted some advice im cleaning the parts for my series 3. Thing like to starter motor, heater, raditator, ect... Has anyone got any good idea on how to clean them also on what is the best way to protect them once clean. I started cleanin my starter motor got most of the grease and grim...

Cheers Dr pepper. i am new to this. Cheers for the help. Now i can test my engine then get back to work sorting the rest of my series 3

One last bit a help. I have the exhaust still on plus the rad. I understand everything up till the starter terminal. Is that the starter solenoid or starter motor. Any help? Would it work also if a connect the coil to the battery and turn the engine over manualy? or am i total lost. Cheers

Hi ya. Can anyone tell me how to test to see if the engine will run before i put it back into my landy. i do not have the key ignition part. is there anyway to hot wire it or something. i have seen a pic on here of Sean rebuild. How do you do what he did with his engine. Cheers

Hi ya all I was wondering is it possiable to put defender doors onto my 1975 series 3. If it does go is there anything that needs changing. (because i want windows that wind down. not slid.) Also i was Wondering if a defender dash could go into it aswell with out much work. Or is there any other...