Search results

Also it's worth noting that you can get into the immobiliser settings on a Hawkeye diagnostic tool to 'remobilise' when unlocking with the key.... I had it last year while on holiday, I ended up getting it unlocked with the fob and didn't lock it again after that :D

http://www.discovery2.co.uk/Fan_bearing.html Bloody expensive for what it is :confused:

Can you move the pulley up and down? My last td5 the bearing was shot and I could move it up and down but it didn't make a noise....

Hey neighbour :D The closest landy specialists we have depending on where you are in Telford is Roean in st George's or Clarke's for landys in child's ercall :)

I would say it sounds like my ace pump did after it lost all its fluid.... Or viscose fan bearings maybe....

In your last attached picture you can see two of the screws on the right hand side :)

From what I remember it's a case of a few small philips screws and some clips and you can take it all apart....

Oh I didn't look into the job at all, but seeing that now I realise I have some security bars over my headlights so thats why I took them bolts out :rolleyes:

Eh, I'm confused a bit here.... It's not the two Philips screws you are trying to undo is it? Take the two torx head bolts out and then tug the unit as it has push in pins..... That's all I've done with mine and I've had them out a few times now and without removing the grill.... :)

Classic case of injector seals.... real easy job and relatively cheap too but while you are in there you will want to change the injector loom too and also do an oil and filters change :)

So three cold starts later and it's firing in less than 3 seconds and the power has changed, before it would get to 3k and stop pulling as hard yet today it got round to 4k before I realised what it was doing..... I don't remember if I've ran it so low since I've had it, as it's a lot better on...

Seems like they have exchanged the photo uploader for more adverts....:confused:

Well the inevitable happened this morning.... I had quarter tank of fuel but I thought I'd put some in anyway, half a mile ish is started misfiring but it kept going but right as I pulled up at the pump it cut out on me :rolleyes: filled up, did a full prime sequence but would it buggery...

Yep, there doesn't seem to be a resolution to the issue either :confused: I've got loads of pictures for the photography thread :rolleyes:

Doesn't work on my phone....:rolleyes:

I'll never put them flat blades on a conventional arm again, the arm was intended for regular blades and the pressure from the spring is distributed across the multiple points on the blade but with a flat blade on same arm the pressure only ever acts on the one spot which inevitably leads to the...

Not too far away from you.... https://www.neildavies4x4.co.uk/#contact-us Or https://www.roean.co.uk/ Or a little further away https://clarkes4landys.co.uk/ I've zero experience with any of them mind but I grew up by where Clarke's is and hear good things of them :)

Some good advice/help here :) No one has mentioned about doing the fluid change, running it for a week and then doing it again though.....

That is way over my head, I'm good with practical things not electrical things :D Years ago i would use botophucket but I abandoned that when they started to want money :confused::confused:

I use me phone :rolleyes: If there is one thing I really like about this forum it's the photo uploader :D