Search results

Many thanks for the info, I will see what the connecter consists of, according to the manual I have its located under the drivers seat. Can't say I'm a dab hand at soldering LOL. Its actually my brothers car and he was going to have a coil spring conversion done on it. I'd rather he stuck with...

I am trying to repair my 1995 RRC LSE. Removed the air pump/dryer assembly with the intension of overhauling them. The pump was only raising a pressure of 15PSI so thought that this was a good place to start. Isolated all four spring bag units and the car has stayed up, so all lines and bags...

No mate can say I have. I’ve got Delphi 150e as I mainly work with Mercedes but sadly won’t work on the discovery. What do they cost? I’ve heard they are really good

I’m not to bad with Electrics as I was motor technician 30 years ago lol so a few things have changed since. Things are so fiddly and complicated these days and turns repairs into an expensive guessing game. I’ve also got an ACE fault to .

And no heated mirrors. I’ve pin tested every wire on the circuit as I have short to ground But it’s not the wiring I suspect the fuse box as that’s the only thing left. I removed it to see if there was any signs of burned connections etc but it looked fine. I’m going to replace it next week to...

Did you make any progress on HRW fuse 8 blowing ?? As I have the same issue I'm of the opinion it may be the fuse box itself

Any one know whether the Delphi 150e is compatible with 2003 Discovery 2? I have ACE EML and ABS lights on

Cheers for that

Thanks for that is that a RAVE manual

Thanks I’ll see if someone can send me a schematic diagram

Who’s that then?

Anybody out there had this on a 2003 Discovery 2 TD5. Fuse 8 for HRW and HFW and heated door mirrors blows immediately the HRW is switched on. It’s 30amp so it takes some fair current to blow it. I’ve no wiring diagram unfortunately. But any info greatly appreciated

Is the fuel pressure sensor also act as the pressure regulator on these L320s as I know some commonrail systems adopt this system

Haha I was going to try the old “sniff” trick as if it runs on that the engine is mechanically OK. I’ll pick some up tomorrow and cross my fingers Cheers

The engine does fire very now and then. But only sounds like a single fire. P0087 was stored on Land Rover diagnostic. But on Delphi FP reads 600bar when cranking. So a bit confused.com Anybody tell me where the fuel pressure control valve is located? As I’ve had these fail on Mercedes and lost...

Anybody know what the correct fuel pressure reading should be for RRS L320 2.7 2007 model. I bought it as a non runner so starting from scratch. The usual crank snapping isn’t the cause as it turns over nicely. But less than 1 bar on diagnosis reader. Are HP pumps common to fail on these ...

Thanks for that. I'll see what other diagnostics I can call on. as the snap on thing seems useless.. I was originally investigating a SAT NAV issue which I've fixed now. Sure these other systems were OK previously? I've re traced my steps to see if anything disconnected but no joy. I'll get it...

Hi all Anybody had L322 2004 BCU issues? My car has the following systems inoperative::...... No interior lights, no remote CDL, no windscreen washers (wipers work) no heated seats, no heater control panel, EAS inop. Andy kindly sent me all the RAVE manuals, which lead me to the BCU being...

Hi there I know some time has passed by but did you sort the drain problem as I have exactly the same issue? on 2004 Vogue TD6