Search results

Hi I had weber on my last one and agree, it installed a bit of confidence when going on a long trip..........you can fix it if it goes wrong and it will run on lower grade fuel.......I do like the efi on my disco. Thanks for the offer .......in Glasgow though:(

Hi again yes correct part. On n/s inner bulkhead same as one in my 80's mini tried it on mini and it seems ok ..... Going to try crank sensor next . Appreciate the input . Regards John

10 miles south of Drumclog

EFI

??

Drumclog is good and about 12 miles from m74

Thanks for response , tested quite a few things on disco today, can I ask a question regarding the inertia switch ...when switching on and off is there pronounced click ?

Hi again .....I now have the ecu talking to becu , what I don't have is a spark at the plugs any thoughts? Also would the nanocom record a faulty coil pack,relay or crank sensor ? Many thanks again

Hi ended up buying one. cheersJohn

Sierrafery.......can you help please. Cheers JohnJohn

Thanks Peter.

That's done . Cheers

Some help please, I have recently had to replace the ECU on the above , I have used nanocom to install the ECU but have encountered a problem , 1st time with Nanocom so good chance its me! The car wont start and fault code P1674 is coming up on Nanocom message is 'imobiliser incorrect ,code...

Thanks Brian I will put my glasses on and have another look......:)

Disco 2 V8 2000...... On the rear of the binnacle there is a wire (brown with black trace) coming from binnacle plug to dash loom , can anyone advise what this is for ? many thanks John

Hi All ,can any one assist with nanocom or hawkeye in the glasgow area ,I looking to see if anyone can assist in programming my new ECU in disco 2 V8. Best regards. John

Thanks again Peter that's it all finished and ready to go ......just looking for someone in the glasgow area with equipment who for a fee would program my new ECU......anybody know anyone? Best regards John

Hi Peter, some advice again please? On the fuel rail loom (injectors) there are 2 wires 1 on each side with 5mm electrical rings fitted (sure they are green might be yellow) is 1 earthed onto fuel rail mounting bolt and the other on to bulkhead (conveniently place captive screw head) many thanks

Peter, I managed to obtain the 2 required brackets from a colleague last night, many thanks for all your assistance. Regards John

Thanks Again Peter any suggestions on where would be best to sources bracketry from plenum ...throttle/cruise cable bracket and one from near side at rear. cheers John