Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. J L Carr

    P38A Compressor

    What did you do on the ends of the pipes, I was told to run them though a pencil sharper before fitting them is that right.
  2. J L Carr

    P38A Compressor

    Hi Guys. I now have 3 6mm joints to use, whitch ones would you recommend to use on putting my air lines right as I have just looked at the ends the go into the EAS block and they look worn out, so answers please Guys. No 1 the brass type or No 2 the full black one or No 3 the one with the blue tips.
  3. J L Carr

    P38A Compressor

    Another quick question, a couple of my air lines that fit into the EAS block look a bit short especially the back 2, I was wondering if there is a way of extending the pipes,as I have some pipe the same size and strength but how to join them. as I think because there 2 short that's why the back...
  4. J L Carr

    P38A Compressor

    But if you take the soft backing off, (as the covering is like a rubbber) then repair it what can you use to recover the back again, as I'm going to pick the covering off and see what the problem was.
  5. J L Carr

    P38A Compressor

    Hi Wammers. I gather your talking about the green unit with the 2 red wires coming off, all I know is I tried eveything yesterday but nothing was happening but today after changing the whole unit it's all working. Again Thanks for All your help. :):)
  6. J L Carr

    P38A Compressor

    Hi Guys. Well tried it again but to no avail, so went back to hard wiring the power so ran the compressor till it told me the car was at road height but then looked at the car and here's the best laugh, passenger side front and rear at off road height front drivers was at road height but drivers...
  7. J L Carr

    P38A Compressor

    Hi Datatek could you tell me whitch is pin 5 on the relay as per picture, as you can see there is only 4 pins and as for the purple wire the one in the picture is the main power wire, the blue wire is my temporary power wire to make my compressor work.
  8. J L Carr

    P38A Compressor

    Well done a re-check and still no power to F40 with either the ignition on or off as well as the other 2 fuses, is the a jumper I can try to the relay to see if that area is working.
  9. J L Carr

    P38A Compressor

    Hi Guys. I'm not even getting any power to the main 30 amp fuse nothing to either fuse 44 or fuse 17, changed the whole lot and still nothing even renewed relay RL20 just to be on the safe side. But there is no power to the whole system, so that's why I'm wondering if there is a hidden unit/fuse...
  10. J L Carr

    P38A Compressor

    Just checked the 30 amp No 2 fuse and it's ok,gave the 3 wires a volt check and till nothing from the main power cable, but I have power coming through a small black and purple cable in the block never noticed if this had power in the first place I thought it was an earth. It runs into the...
  11. J L Carr

    P38A Compressor

    Hi, not getting any power up to the main connections as I stripped back the sheathing about 200mm back down the main power cable up a volt meter on it started the car up, but no volts coming through. So that's why I checked both fuses and relay,so now puzzled.
  12. J L Carr

    P38A Compressor

    Hi Guys. Help needed, I am not getting any power to my Air suspension compressor all was working fine the day before but now nothing, done the usual checked the fuses and relay, changed them but to no avail. So checked if any power was coming though the main cable and nothing, the only way I...
  13. J L Carr

    P38A EAS box

    Just to give everyone an update about the suspension it stayed up at normal height for over 5 days then it started to drop just a little, so because the pipe work is now in the right order by the plan I had sent over it looks like all is ok up to now. Many Thanks for All your help.
  14. J L Carr

    P38A EAS box

    Well because of the link Tenebraux posted I had to change around the pipe works and up to know the car has stayed up and at the same height of 480 mm from arch to centre of the wheel, it has not dropped in any corner. Lets hope it stays that way, so I'll find out tomorrow fingers crossed...
  15. J L Carr

    P38A EAS box

    The problem I'm having at the moment is my drivers side rear keeps on going down, it's not the line or the air bag because I've just had the whole lot pumped up with the Schrader valves up to 55 cm to gain access to the tank to put the new pump in.the car never drop a lot only a couple of cm's...
  16. J L Carr

    P38A EAS box

    Thanks, that will help a lot, it will give me piece of mind that there in the right order.
  17. J L Carr

    P38A EAS box

    Hi Guys, could someone tell me sometime, on the side of the EAS box that holds the compressor and the valves there is a bunch of numbers, going from 1 to 11 what do the numbers correspond to. Just to make sure I have my air lines in the right place manly the 4 for the air bags. Thanks.
  18. J L Carr

    P38A Starting problems.

    It's alive, well after the struggle to put the tank and guard back the problem was then putting the filler pipe back into the tank pipe, so then given all pipe work back so switched on and away she started, great so a couple of jubilee clips to fit and then the wheel arch liner and then back on...
  19. J L Carr

    P38A Starting problems.

    Cheers Guys, just got it from Island 4x4 full total £25, so hopefully have it soon and get the tank and everything put back while we have some good weather and not back to work yet. To everyone in the Landyzone stay safe.
  20. J L Carr

    P38A Starting problems.

    While the tank is off I noticed that the rubber fuel filler pipe has a few cracks in it,my question is does anybody know where I can get 1 from with out going through RR themselves. Thanks.
Back
Top