Search results

Hi 'Duke. Apologies, the Mrs returned from hospital today with #2. Hands = full! All those bits are yours. PayPal to [email protected] if you'd please. Extra £3 for P&P, the rear brackets are a bit big for an envelope! Ta.

I'll PM...

Hi Bob.H some interest in the mud flats but no one has committed yet; if you say you want them thentthen are yours. The side light is plastic lensed. Cheers

£40 plus postage for the lot?

All gone now, thank you.

That's interesting. I've got some square, recessed window side panels for my marine blue 88 van eventually; I was going to go lime with them for the original look but good to know blue could be original too.

Evening. Can you remind me, are 3.54 standard or the high ratio jobs from RRC's etc?. Ta

I've a slow turning starter on my 2.25 petrol. New starter and leads. I suspect the solenoid but I'm slightly nervous about shorting it with a screw driver. Am I being a big Jessy? Also where are people getting new solenoids from?

190 you say? My 'other' wheels :D

Had a bit of work to do on the front end but managed to find a cheap substitute wing. I don't think any one will notice.

Yeah, same yellow covering. Garden hose, like it.

F - that! My fuel consumption is poor enough already :D

I ended up cutting the rubber plug covers to open the holes up a bit, allowing disassembly of the ceramic plugs. I'm still not sure why yours wasn't long enough ??

Now this I can understand. Best way to check play in either?

Yes had both props apart and rebuilt with new UJs all round. I'm afraid I don't know if the grinding was there beforehand. The grinding does go away if you take the roof off, however. :D

Looking at this month's CLR, there is a report that an out of phase prop shaft can cause an grinding noise on the over-run, a problem I'm facing. Can anyone shed any light in this? I can understand constant vibration due to poor prop phasing but I can't get my head around a grind on over-run. I...

Either that or we all are.

Load of old rubbish then?

I stuck the relays behind the front panel, I tried to hind then behind the metal work as best I could to hide them from view and road spray I guess. I'll try and get some pictures over the weekend. I seem to remember the wiring round the light fittings being a bit less tidy.