Search results

Yes, also interested to know this please! I have managed to get the lock barrel out. As Capo suggested, I bent the tabs down on the nut, undid it and removed along with a sub-assy part and then pushed the barrel back through; it literally dropped out. So that was good. What isn't so good is how...

I think you might be right about the hex hd bolt as I've just had the new barrels delivered today and at the opposing end to the key slot is a female thread. So I will try and bend the tabs back and undo it and see what gives.

Right. I'm still mystified how I can release the lock barrel from the door latch! I need to get the door handle/lever out as well to make it look like new again. I've attached some photos of one of the latches. Does anyone have any idea how I disassemble the barrel & handle?

1985 90 Truck Cab, wind-up windows (5mm thk glass): I'm going to do a complete rebuild on the front doors but concerned about whose make of parts to use for the glass surround seal/channel etc. I'm wary of using Britpart but no doubt oem will be prohibitive once all the parts are costed up for...

Capo, thanks for your help. I'll have a look later and report back.

They're pretty grim. I might bite the bullet and go for new (LuH) frame/skin assy from SP4x4 and build them back up, then at a later date, rebuild the exisitng ones and flog them on. Does anyone know how to remove the lock barrels from the LuH door latches?

1985 90 Truck Cab with single piece lift-up handle doors. I'm in a bit of a quandary over my doors. Just getting to the stage of requiring doors to go on after 3 years :eek: I have a spare set of push-button ones as well. Both sets are similar condition (that means pretty @iss poor tbh). I've...

Yes I do but it's clearly a sub-assembly part of the loom don't you think? So I would expect that sub-assy part to have a part no. and hopefully be obtainable?

Just bumping this...has no one any clues?

I seem to be missing part of the wiring that plugs into the multi-connector pictured. Is there a part no. anyone can offer please?

Give this a try, if the link doesn't work just google it manually: http://www.vehicleglazingspecialists.com/ They supplied me with a tinted one-piece replacement glass together with a fitting kit and seal. A much better solution than the leaky, rattly two-piece original.

Either that or it's just allowance for Land Rover build tolerances? :)

Lynall, mine is a '85 90 Truck cab so I think I'll probably go with Paul's dimensions but thanks all the same.

Thanks Paul & Lynall, fantastic help guys, cheers!

I'm about to install new seats onto a YRM repaired seatbox but have no reference for where to drill for the set frame fixings. Can someone be good enough to take a reference measurement from the outer edge of the seatbox to the bolt hole centres? That would be a great help. Many thanks in advance.

Ok, many thanks for your help.

A fair chunk...battery box, both ends and all tops.

Anyone?

I'm probably being a numpty here but, having built a new YRM seatbox and installed it, I ordered some modular seats from Exmoor trim. The position of the seat frames on the seatbox isn't self-explanatory. Is it ok to just position the frames on centre as best I can by eye or am I missing a trick?

Thanks flat.