Search results

Drawing in air?

Cheers Grit Valve

Think my ball joint's might need replaced, Is there a special tool to remove and replace the ball joints?

Cheers, i'm sure I read that here recently

Seems like your right Wammers, :D did a search and it looks like a right pain in the arse to do :D

Cheers, I've got a squeal coming from the brakes, so will have a look at that as well

My blend motors are playing funny buggers now :( Are they easy to get to?

My P38 is pulling to the left, so need to get it jacked up to see what the problem is. Wondering if it's an alignment problem. I've also noticed that I'm getting slightly less MPG (BMW 2.5 TD engine) Been told this could be due to diesel thickening when cold. I still need to get a fuel heater...

I use the Oxford Oximiser on my bikes. What about a solar panel?

Cheers Datatek. Am I better to read the faults when the fault happens, or will I still get a fault code reading even though the problem seems to have sorted it's self?

Got an EAS warning again after I started the engine then immediately wound down the front windows. The pump works and the suspension lifts ok. Fecking weird, because that's what happened the last time, but it sorts it's self out.

I seem to be getting the same MPG figures as you. Is there a reason why I am getting less MPG in colder weather than I did in the summer?

I changed all the electrics on the Classic Vogue I had. After a week it would not start or would run rough. After a lot of ****in around, I replaced the new rotor arm with the old one. Ran as sweet as a nut after that. Apparently they don't like aftermarket rotor arms.

My P38 is pulling slightly to the nearside and I also need to look at small bit of saggy headlining and order 2 new rear air bags.

The heated screen works ok, so not in a rush to get it done. Don't know why I said bible, but suppose it's relevant :D

Ahh, blend motors! could not remember what they were called. Yes, got the bible displayed on the HEVAC. At some point i'll see if they can be adjusted manually to divert hot air to the screen for the winter.

my heater vents are not blowing onto the windscreen. Easy fix?

Thanks for the replies guy's. Hate auto electrics. Checked relays and now got power to the injectors and air idle control valve. Rechecked the crank sensor with a new multimeter and got a good ohms reading within tolerance, so that's ok. Though the cam sensor is not giving me a reading...

Good find warrior, gonna check that now. I also checked both the cam and crank sensors according to the instructions I found on the internet, I did not get an ohm reading from either suggesting they are fooked, I also checked a spare cam sensor and looks like it's fooked as well. Tried the...

Still no joy from the spare key