Search results

Neither :)think I’ll have a sharp learning curve with her,the fuel is leaking just above the chassis leg drivers side rear not had chance to find the engine oil one yet and the diff I’m not sure what’s on there buts it’s a mixture of muddy water and oil that’s leaking of the front.

Tbh I never even knew they came in a 3 door,was there many made?

Picked up 3 door 200tdi today Happy enough with it,I have owned my Freelander for 5 years now but needed something for green laining,but there’s some problems I’m going to have to fix,Speedo/miles not clocking up,leak from rear diff looks like the pinion,very small fuel leak and an unknown oil...

Think it’s surprised a few people including me. Just looking for an upgraded clutch now,the wife gave me the go ahead so I’m taking this opportunity if anyone has any suggestions

Just posted your other pictures at the same time :D I’ll follow you next time.

Had a great day out around North Yorkshire dales even if my clutch has started to slip :D Thanks Ian Martinson for letting me pinch your pics.

Sorry been at work,it’s already on there.

Stolen last night while the owner was on holiday,Its one of the lads from Northeast Glass.

Mine where,which I was surprised at everything in normally a pain in the arse on the car I just got the engine warm first,other people have had to use pullers on them,I would get them tested first though make sure you’re not wasting your money.

Mine was doing the same I ignored it for years,then start running ruff for a few seconds.The last few months it got worse I changed the injectors and two were well clogged up with carbon gunk put some good second hand ones in off a rover 75 and it’s cured it.

I never on mine rob did cut the inner arch though on full travel(if that’s the right wording) it was just catching.

I would rather change a bearing than see my tyre overtake me :eek: lesser of two evils lol

I’m not sure rob I got mine second hand,larger off set as well so saves you money on spacers and IMO there safer not overly keen on spacers unless you fork out £200odd quid for a decent set.

I only went out for some milk,I could walk it in 5 minutes,I was out for 3 hours :D

Had a little play in the snow yesterday,childish :oops:

My modulars are hub centric but there off a Honda CR-V (older type)they have a larger off set so I managed to fit 235/70/16 Bfgoodrich AT without spacers that’s with a 40mm kit and I would did fit the camber bolts on mine.

Thanks lads,just seen it didn’t have the Center silencer ,Just ended up chopping them out and exiting the side.

will an L series middle section fit on a td4 I have had a search and nothing unless I missed something.

I had the bottom one my advice would be save a bit more money and get it remapped,the car seems to perform better through out the rev range and I’m getting better MPG where as the chip didn’t and also caused problems the low pressure pump(could have been on its way out already)can’t comment on...

I had a similar problem with mine which showed a low pressure fuel problem code on one of them gizmos has the loom connector to the fuel pressure sensor,But like GG it can be a few things.