Search results

Is it this one do you think? ERR4388...

I will start by replacing the plenum chamber feed pipe, which I think is causing the leak, give it a good clean and monitor the situation. I found this drawing on landyzone, I think it is pipe number 8 that is leaking. Please could somebody with a parts catalogue tell me the part number? Thank you

I think you guys are right about the hose. I have found some more coolant in places above where the gasket would be. Is the hose that needs replacing the one in blue? In green are areas of where there is coolant residue. The one at the back is beneath the air intake, where there is quite a bit...

Right, it is coolant. Wiped it with a white cloth and appeared red-ish plus black gunk from dirt. Head gasket on its way out do you think? I will probably give it a good clean and monitor it. I have never noticed the engine to be over-heating, no white smoke.

I will do some more investigation tomorrow and report back.

Hi guys, finally got the P38 off its bump stops thanks to Kurt! :) There seems to be a pool of fuel here, any ideas what the fault could be? One bank of the cylinders seems greasy whereas the other side is clean an dry. The car sounds as though it might be missing a cylinder. It is a 4.0v8 Thanks

Does anyone have this manual in PDF please? STC9021CC Parts Catalogue 1987-2006. I have the older one from retroanaconda, but some of the part numbers aren´t quite right. e.g. I am looking for the two front door bottom seals...ninety and oneten it is ALR6250... is that also right for Defender TD5?

Hi Kurt, i would like both please! I'm on holiday till wednesday, can you hold on to them till then? Don't have access to my bank account from here. Cheers Mike

I bought some aftermarket black ones a few years ago. Possibly britpart, I can't remember. But they looked ****e and cheap! Spray the originals or get them upholstered.

Hi, anyone have a set of roof bars for a 90 defender to fit along the gutter? I need them for attaching my roof tent. Cheers Mike

iron-man shocks. Britpart and terrafirma were shocking...no pun intended

Could be as basic as a clogged fuel filter... my brothers Toyota had that issue, see other recent post

I have been working on the roll bar strut for my 90 hardtop to soft top conversion. Ok, I haven't actually done the fabrication, but I have been managing it :) The roll bar from All Wheel Trim is absolute ****e...heavily distorted and the original strut didn´t align to the body work. Plus it...

Where are you based?

I am currently abroad and getting scuffing through customs adds quite a bit of cost

Probably a long shot, but has anyone mixed Caledonian blue with Humbrol or Revell modelling paints? Just need to touch up a few rivets and was wondering which shade is closest or which two or three mixed up would be close

get some copper grease and probably some penetrating/releasing fluid. Engine/gearbox/diff oil as well perhaps, but surely that is available in Africa? Perhaps brake and power steering fluid also. Grease for your props and hubs if you are planning on doing anything with those. Brake cleaner or...

I sent a message to the owner but he hasn't replied yet.

Hi, I have been offered a very nice 1994 Left Hand Drive 200tdi RRC for sale in dark green metallic. It is a hard dash model. It is not in perfect condition, but decent, driveable and not rotten. Has an MOT (well, the equivalent of an MOT). Matching numbers, factory engine. Would probably need...

Hi Kurt, do you still have a rexon P38 EAS valve block?