Search results

And they do left/right by the heater controls

Search for rdx side pods Mine looks like this screws into existing holes

I have a pod which goes on the heater control. Space for 3 switches. Fog light switch replaced there Now off to find the make for you

Give it a good run out. It will have a lot of damp/crap in it. They clear out after a few hot miles when everything is up to temperature Gun mount behind seat. Safest place as less stuff to damage it. Can be a pain but a lot safer

As it’s a commercial it would state if it’s a higher rating on the chassis plate.

Bit of rubber under the terminals/clamps and under the bar gives piece of mind

@dag019 Truck cab metal work

You see my Hicap… it really a special.these are a few changes and to the untrained eye every thing is standard… I can turn tighter than you & fit in smaller space ;) This was my last road project. But done a few off road racers upto 8years ago when I hung the spanners up for fun stuff.

On the unleaded fuel I was on 6btdc.

Well sorted..

Will do this Sunday.

You want to see some of the things I have built.. just for fun or to see if it works. My tube/box bending skills improved but as for welding someone else always done this while I was on metal work. I get arc eye very easily… so like to stay away from the bright light as much as possible. When...

Early v8 had a facet type pump by the tank that pulled from tank. Go to a LR site as these are cheaper than a facet. (Max 6psi) Of course that’s as long as the 3.9 is in carbs.. If not you need a higher pressure pump (bullet type of a Ford) & regulator to get correct pressure

Thought… Can you drill from the top from small to large drill downward until you break the weld on that washer? Replace them with threaded rod. No need to remove or raise roof.

As they are water trap areas make sure you have a supply of the fixings incase you have to replace

You will need to lift the roof a bit to cut the bolt & then remove the disk part. Parts look like the earlier photo from @kevstar Once part removed you could just replace with long bolt @ washer into the bottom tube

Are you taking the roof off? The other 1/2 of the bolt will come out

Some of the braided use banjo bolts on the end for the caliper

Are the rear axle one longer? But the ends(shape) may be different. Other option remake pipe to suit newer style, Or Get some braided extended style

So question time @bankz5152 How have you fixed the rock slider to the chassis? (Bracket design photo as well please) Did use 1 length for the step,notch out & bend Or cut & weld? Unsure if you posted any photos (Its just so I can get my brain cell into gear to see if you make these into a...