Search results

ECU definitely isn't behind the glove box.....

Oh wicked, well done on sorting yours :) was it just the one side that had gone or had it killed all of them. Going to pop out and try my luck now :)

Hey I Don't want to change the whole seat and frame to a 5dr one, it's the frame on the 3dr that tilts/slides the chair forward to enable passengers access to the back. So I am hoping to change just the chair, so if I can separate a chair from a 5dr seat frame will that then fit on my 3dr seat...

Anyone know ? :)

Had some good feedback on this, appreciate everyone's input :)

So, plan of attack with this window. 1 check cables at door 2 door off and check for any blocks in runners 3 check for voltage at motor 4 check window ECU Anyone got any other tips? :)

Hey everyone. So the drivers seat in my 3dr disco is nakered, it's collapsed at the back so it drops right down where your ass sits and it won't extend right forward, so at present my dad can't drive it as he is a bit shorter than me and its bloody uncomfortable. Does anyone know if the seat...

Leaky steering box now.

Hahaaaaa. I'll start knocking them together then :0)

Does it come with a travel/carry case?

Better weight than the Halfords one too :)

Just read it, looks good :) thank you.

Oh that's not bad, still get a good 500mm lift from it :)

Found it, same level. :) section 1•22

I assume the rear axle is filled to the same level as the front? Can't see anything about rear axle level in the Haynes book?

Just jacked it up and checked bolts. Most of them where all 3/4 of a turn loose with a few of them being over a turn loose. All tightened Up, let's see how it goes. Just going to check level in front axle, full it to the middle drain hole right? Just noticed I have lost an inch of coolant...

Thanks chap :)

Oh my bad, I'll jump on that now :)

Will check bolts tomorrow. Although the Oil is directly under the Swivel, it is defiantly leaking from the join, I can see the droplets on the bottom. If and when I have to replace the gasket, could I just use a gasket seal on both sides of the gasket and then sealant around the edge of the...

That would be nice....... :)