tomke92z's latest activity

Funnily, because I have a dodgy back, I swopped the seats when the one on the driver's side went, A little awkward when it came to adjusting the back etc but feasible, and drove it like that until it went too! So I took the original driver's one...

Ahem. Exmoor trim is NOT original Land Rover. It looks as if some previous owner has done an Exmoor trim job. Believe me the flap at the end is about 2 to 3 times as wide on an original. I took the originals off both front seats in my Disco 1...

Thanks. It's my first and only Disco so I don't have much experience. I saw the video from Exmoor and thought it's the default setup. I'm not very good at sewing, so I was afraid I might mess something up – adding extra foam seemed like a safer...

Thanks a lot, guys! I read your replies too late and had already cut my seat. But I understand that if I had just pulled it with a jack or a pry bar, I would have removed the headrest along with the plastic parts that normally stay inside the...

First of all, thanks a ton for your responses! You helped me a lot! Have a look at this screenshot from Exmoor Trim's video: Looks pretty much the same as in my seat, doesn't it? I took this advice and did just that. I tested it and the lumbar...

I dont know the seats. But as you tension it just sort of pushes the cushion forward with a bit more support, yes? If so could you not just put it to the slack position and the place some 5-10mm medium/high density foam in there. J

Right, first off, those rows of stitches are not how they come from the factory. some previous owner must have taken it off and stitched them together like that. from the factory the flaps are glued down. Secondly, I can tell from looking at the...

I've repaired both of mine and all I did was superglue the flaps back in place to where they were when fitted. I get the feeling you didn't relax the mechanism to its max and then pull the flaps back to exactly where they were before trying to...

Hmm, I don't think I get it 😊 I didn't do anything yet, just took off the fabric to see what's under the foam. I didn't mess with the lumbar support yet. The strap is nicely attached to the flaps but the strap itself is too loose.

Ok, I didn't expect that but I need to cut through the foam. Explained here: The thread can be closed.

Hi! I've taken my chair apart and I'm looking at how the lumbar support works. The mechanism itself seems fine, but the support is barely noticeable. It feels like the strap isn't pushing out enough because it's not tight enough. Is there a...

How do I take out the headrest?! No matter how hard I pull, it won't come out. How do I unlock it?

Early ZF made ones had a spur(off to find a part number)

And… Stc3075. Fitted to wolf

Wow! So most likely mine also had a spur which has been broken off. What is the purpose of this spur? It's a vent or sth else? How the fact that it's broken off affects my power steering system? I have some leak but I cannot trace it. The...

Hi! Is the hole in the picture a factory vent for the power steering system in a D1, or is it damage to the cap?