Recent content by Sandloverl

Sorry I replied to myself. The part cost 50 pounds and was not a land rover part. Is the master cylinder hard to fit if I get the original part.

I think it was a non land rover part. It cost around 50 pounds. Is it hard to change.

Sorry no I don’t have a pic. The car was recently in for a new slave cylinder and when you look at the reservoir under the bulk head there is a slight weep of fluid. I thin they changed the item near the clutch lever.

Thank you. Should the yolk be loose on the shaft.

Hello all. I have a freelander t d4 that is reluctant to go into reverse. As I look at the gear quadrant the rocking yolk is moving on the shaft and I’ve been told the roll pin will need replacing. ? My question is about the alignment of the yolk to the the shaft to remove the pin. Sorry if...

Hello from Yorkshire