Check the small pipe that goes from the top of the rad to the expansion tank👍
The cap on the expansion tank can give up as well but then the coolant would run towards the bulkhead🤔
ok, the problem is solved for the time being.
unfortunately I didn't proceed systematically.
what I did:
- pulled out all fuses (including those in the engine compartment)
- checked - all fuses were good - treated with contact spray
- Checked the...
That was a super slippery hill. You can see in the terribly fimled decent video theres abit of a bump in the road and as my front wheels drop off they lose traction and from then on the ABS just decided no more brakes. I basically just plowed...
Over here, there is a company called Colis Privé used by Amazon and others, there are 3 houses in our lane, they dump packages in the drive to the farm at the top of the hill whatever the address is.
Round here they've cut back on staff on only deliver every 2 or 3 days depending where abouts you live. Special deliveries it's a guy running around in a van but normal 24/48 service can take 3 days.
Ball joint steering knuckles didn't get done Friday. Ball joints had arrived on time but not the shaft seals. it's a set back, now everything here will be done this week. These things are sent to try us :( :D
Can buy printers quite cheap now. The first one i bout about 8 months ago for £80. This new one was £1300 but in my eyes it has been worth every penny. A lot of things I've made i couldn't buy or weren't suitable, so being able to design and...
Today I have mostly been 3d printing replacement parts for the 322.
Namely replacement studs for the scuttle panel and clip down points for the boot floor.
Also 3d printed a instrument cluster mount to use a lcd panel and raspberry pi as the...