Recent content by MontyChambers

Very helpful, tomorrow mornings job, by the way nanocom is running as it should, Hope for clear sky's tomorrow, metaphorically as well as weather-wise!

But how do I change the setting for brake switch 2?

Yes, thanks, I am on that now!

I will by some prayer beads!

My evolution was working fine, then occasionally it would be able to communicate with the ECU but this was rarely, Now it boots to Kernel, Firmware, Graphics, Nanocom Diagnostics Kernel goes to ‘Kernel bootloader activated and switches the unit off The firmware option requires a numeric code...

Just a side question, my nanocm has stopped working properly, I want install firmware but it asks for a numeric code. Where can I find that code

Just a side question, my nanocm has stopped working properly, I want install firmware but it asks for a numeric code. Where can I find that code?

Where are the brake switches to be found? Near the pedal presumably?

I can tick off the ABS sensors as good, The bulb is new I should begin looking at a wiring fault, the wiring all looks tip top though, this truck has been kept well.

Just took it for a spin and still have the ABS TC lights on! I had my nanocom going? not sure what to make of it? brakes feel good.

New bulb fitted, brakes bled, ABS-TC lights still on! WABCO D OUTPUT SETTINGS?

Thank you Mark

Yes, yes, I will go through the decompression procedure before removing the accumulater. Thank you again guys

Thank you both Time saved I shall order a quality replacement today! Once again Datatek, you have saved the day, kudos!