Thought I would tackle the o/s glass channel today. The channel itself was quite sound as it was galvanised, but the felt runners were completely shot and a pig to get out!
After some fighting and swearing I managed to get the channel stripped...
Hi and welcome!
Sorry for your loss. Getting your dad’s Landy back on the road and doing a road trip is great way to remember him.
Lots of good advice and recommendations. Don’t forget to get an agreed valuation and classic insurance to...
Bit more tidying up. This was rusty and flaking everywhere. I meant to only clean up where my fuse box earths but ended up taking the lot back to metal.
Epoxy primered then only had half a can of black left so used some caliper paint
Re shaped the foam backing then stuck it back onto the steel panel using high temp contact adhesive, all the gaps filled with fire resistant expanding foam. Will trim it back and sand smooth tomorrow once its fully cured.
I’ve retrimmed over the...
Lower dash cleaned up small repair done to lower edge, then rust converted and sprayed. Made a new lid out of 1.6mm galv sheet cut shaped drilled and sprayed. Foam all cleaned ready to be stuck on tomorrow when the high temp contact adhesive...
If you've got the go ahead from your financial director i'd get the nice new one. I spent (and am spending) countless hours on it. I do get it about wanting to repair the original though.
I'm hoping to use the old foam, it seems in fairly good condition 😁
Boss lady saw the dash last night and said, don't bother repairing, buy the new one, stop being tight, it's only £600!
Still undecided, I'd quite like to have a go at a repair 🤪
Try watching these halfwits without throwing something at the TV!
Blatantly driving off track on a couple of well known routes in Wales and in general behaving like a bunch of feral halfwits.
Note the GLASS decal on one of them, reminds me why I...
Taken it out for a drive this morning. Cooling nicely, no new noises.
Only issue is a slightly higher idle than before. Pretty sure that’s just a screw adjustment. I’ll take a look when I’m wearing my scruffs again.
Found a nice flat parking spot for the night.
And had a good day on the lanes in wales. Friend decides to drag the trailer round to see how it is(done well,but you have to remove trailer electric to raise the suspension to highest settings)
Top up/fill up…
Engine oil
Water
Screen wash
Kicked tyres
Power steering( looks like a small weep on drop arm)
A fixed a bit of tape to the throttle adjuster to stop the cable winding loose due to diesel vibrations
Loaded motor for few days...
Was that the one near Bath? I went on the Saturday, wasn't too bad. Few bits for sale, nothing exciting. Lots of Land Rovers (duh), and some food stalls. Good selection of Land Rovers to be fair, everything from rough with 'patina', up to...
There’s a series of meet-ups for land rovers across the country organised on FB under the name of Tea on the Tailgate which are getting popular. There are some quite local to me which I will try to get to, subject to other commitments. Has...
This was on again over the weekend. It has had more online advertising this year so hopefully it was better attended. Did anyone go? I worked so couldn’t attend.
Having a look at trail wise and found it a bit helpful. Some lanes I had looked on the OS map have TRO/VRO or advise to only go 1 way. Yes some of this info goes back a few years,so a sites is only as good as the info supplied
Still route...