Recent content by invisible999

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    Now need to fix misfire on two cylinders
  2. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    Update on this matter - bought this item on Ebay https://www.ebay.com/itm/266921777858 After the replacement - I don't see error on GAP ID Tool any more.
  3. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    I checked battery this morning after last night driving and it shows 12.75V
  4. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    Semi-stupid question - how do I know I have it? I spent $800 in one shop after they told me that they have 'engine too rich on idle' error and misfiring are caused by mass air flow sensor. Did replace it mas air flow senser and all spark plugs. I see this from time to time but only after...
  5. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    No lights, nothing
  6. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    Update on this matter - apparently the plug right above the DVD reader where Navigadion DVD is was unplugged. I plugged it back, cleared errors and now only see following ones ACM-Audio System U1A03-62 (2B) Vehicle configuration parameter - Algorithm based failure - signal compare failure ( at...
  7. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    It is US version 2005 HSE. Currently 142K miles on it.
  8. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    Cleared 5 times, same result. Battery is 12.7V
  9. I

    Fauls after reading with GAP IDD Tool - which one are 'real'?

    After getting and registering my IDD Tool I did code reading and it came up with following Using IIDTool BT V4.0 B3998 AAM-Audio Amplifier B1A03-13 (2F) Speaker 3 circuit - General electrical failure - circuit open ( at 2141416 mi ) Test Failed Test Failed This Monitoring Cycle Confirmed...
  10. I

    2005 HSE L322 - correct tire pressure for Nokian APT?

    If you will be in Reno/Tahoe area, drop me a message a I car take you a ride on Old Geiger Grade Toll Road - I live 3 miles away. Here is a good blog post about it with photos but the photos on Alltrails site above (registration required) give better understanding.
  11. I

    Air.Susp.Inactive message on 2005 L322

    One question remains - how ABS 'going bad' is manifesting itself except this 'precharge pump' message? What are other situations/messages clearly
  12. I

    2005 HSE L322 - correct tire pressure for Nokian APT?

  13. I

    2005 HSE L322 - correct tire pressure for Nokian APT?

    The sticker on photo is from door at driver side. Yes, checked RAVE and set 34 on front and 36 for rear. A related question - what should be tire pressure for off-road driving if the road is dirt road with small rocks without sand?
  14. I

    2005 HSE L322 - correct tire pressure for Nokian APT?

    I have 20" wheels and 255/50/R20 Nokian Outpost APT tires. I checked tire pressure today and to my surprise it was set to 30PSI for front and 36 - for rear. The sticker (below) says that it should be 36 for front and 44 for rear. Wanted to check with the community - is it OK to set 44PSI with...
  15. I

    0x0032 CAN bus Fault

    Update/closing the thread - while CAN Bus error remains, the air.susp.inactive message is gone after ABS module repair. I also got GAP IID tool off ebay and now are going thru the codes it reads/generates.
See more
Back
Top