GrumpyGel's latest activity

I think there’s a bit of confusion about this post, with regards to the heater knobs. I don’t have any problems with surrounds - the red and blue, direction or fan speed are all lit up as they should be.What I was asking initially (although I...

Jesus christ 0.2 seconds and 2mph difference. That really is a massive difference. You'll be wanting to weigh the driver next.

Here you go... https://www.landyzone.co.uk/land-rover/heater-control-lights.202204/

The heater control illumination is not just a case of replacing knobs I don't think. Hasn't been discussed for ages I don't think, but there are threads about it. I remember threads about it when I got the F1, but didn't fix it at the time. So...

What ever you do - remove the inside cover on the door before closing it. If you manage to close it, but then can't open it again, you'll be cursing if you don't. I agree, you are almost certainly up for a new regulator (motor, wires and...

Quite coincidental this because I used the manual gear selection in my F2 for the first time this weekend. We went over a pass where plenty of vehicles burn their brakes out by the time they've got to the bottom. I was using it to brake rather...

Finally sorted the soft clutch after replacing the gearbox, new bracket and Slave Cylinder was needed so installed those, and while I was there, fixed a horrible squeal that we had on start, tightening the alternator, what a lovely start now 😂...

Today I investigated the propshaft vibration I was experiencing at 55+ mph. I whipped off the front half and found that the front CV joint was pretty rattly. Eureka I thought, that'll be it. Went for a quick spin with the rear half still on and...

I used the 3D printer at work to print the fixings for my 3 door parcel shelf, it worked a treat. Also fitted wind deflectors, I must say it looks good👍

Hoovered the boot out… I collected enough to make another fox-red lab, if anyone is interested 🙄