Forrest Gump's latest activity

Hello mate. An F reg would not have had the 300 tdi engine. It might have been fitted in place of the original engine. Probably a diesel 19J 2.5. It might have had a bit of ropey wiring work done on it. If you can get yourself a wiring diagram...

It is a shame so many folk, and not just farmers do not take basic care of their vehicles. A good clean underneath once a year and when dry a spray of preservative goes a long way. I was doing similar work on mine recently and all bolts that...

Hi everyone, finally had the injectors tested today. One of them was dribbling all the time so that would cause the issue. They are replacing all 4 nozzles and setting them up to all open at the same pressure so they will be like new. Hopefully...

Your a machine too 🤙

And in between all of the landy stuff I managed to give the bike a service before the trip

Rear wheel arches strengthened with formed inner ali sections panel bonded into place, few other repair sections fitted. New inner wheel arches bonded and rivited along with new floor and rear cross section all bonded rivited and bolted using 5mm...

Remove the 2 screws & replace the O ring… Yep I know how much diesel they loose as it’s happened to me. (Think I turned the o ring over to get me home) Nothing will fall out

New 1.6mm ali inner wing liners cut to shape and ready to be panel bonded and rivited over the original wings to give a smooth as new finish to the inside of the tub, also bonded 2mm sheet to the original floor here it is with some weight on it...

I did pal. Actually fitted new ones as I replaced both doors with new ones. The old doors were rotted out. I just wonder if the heater matrix was not of best quality and was not doing the heat exchanging effect very good. Checked every part of...

They still should be quite warm, did you check the door seals etc ?