discool's latest activity

🤔 my 1987 RR wasn’t equipped with dim-dip nether was my TVR in 1985.

Yes, a resistor which is mounted at the rear of engine bay, just unplug it to remove the dim-dip function.

🤔 Pink relay ? No such thing fitted to a D1 and the only item that dips the headlights with the side lights on is the lighting switch. With D1s dim-dip feature, when the side lamps are switch on the headlight dip beam is then on but in a dim...

It works again now so we will pretend it never happened

No. So unless there is a timer unit somewhere set at 10 minutes 🤔 then I would suspect an iffy light switch or intermittent wiring connection.

As aways now, expect questions on issues with the D1 & 2 have already been asked on LR forums https://www.landyzone.co.uk/land-rover/discovery-2-tailgate-lock.127980/

Just pop into the the main dealer and pickup a free accessory catalog for the DS, or as we can nowadays just Google 😊 https://accessories.landrover.com/gb/en/discovery-sport/carrying-towing/carrying/vplcr0137-roof-rails-silver-finish-panoramic-roof/

Other faults with the fob that will give issues is, iffy button micro switch's which can be replaced, if your careful, and battery terminals at their joint with the PCB

I've just found my second key and this one has enabled me to open and close the vehicle remotely! I'm a bit ashamed because I should have thought of that first. So my problem is really with the key and not with anything else. I'd like to say a...

The Wanner gun has an air release valve, so no issues there. 😊

I purchased mine back in 1966 when I purchased an MG which had grease nipples on the steering. Still have it for my disco now fitted with a flexi spout to make things easygoing around both props.

I'm almost certain that here is no MAP sensor on this system. The ECU uses a full range throttle potentiometer to determine a load signal. You will need to check for flash codes. The 14CUX ECU was a primitave unit so if you have an engine light...

Your central locking operation is simple to the D1 as much the driver’s door lock is called a master the others are called slaves so when the drivers door locks or unlocks the others follow, its a long while ago but the D2 forum was full with...

The good news the mechanism appears ok, but the standard procedure as stated in the owners handbook is when locking with the key in the driver’s door lock you must always unlock via the fob otherwise the alarm will activate, and that isn’t ? ☹️

Best to decide if it’s mechanical or electrical. Mechanical issues were known with either the locking or unlocking motor, both are housed within the drivers door lock, the issue was resolved. When locking or unlocking do u hear any sounds. For...

The retaining screw is to ground the receiver against possible electromagnetic interference, the item’s functional earth is within the loom, possibly a black wire.

Anything can be cut out with a Dremel, it's only a plastic moulding

All you will find regarding a heat shield under the vehicle it will be bolted to brackets below the floor and positioned above the mid exhaust box, although some times with after market mid boxes it attached. If with the D2 you need the heater...