Recent content by ciderman

Many thanks- had a good look and seems that none of those fit mine- about 650mm

hi has anyone successfully refitted these themselves? . Are all of them the same size? we've tried and tried but the damn things pop out or fall inside the vehicle. with 3 of us working on it (200 years combined age and much vehicle experience) and we are all thoroughly pi$$ed off with the whole...

Hi, found new front propshaft is 2 inches short (25 inch) than the old one and flange distance is 27 inch. I also found series 2-3 props are about 24 inch. So too short, what prop do I have??? thanks

thanks

Has anyone been able to install the clutch slave rod to release fork clip, via the slave cylinder hole? asking for a friend...............

PEARLS OF WISD Clingfilm worked!

Did you have the box on its side or vertical?

Weber- for best economy- Su conversion for more power.

watched that- his slipped in easily.

I'm losing the will to live here.......

I am just reading about the differing measurements in the a-C suffixes. might have a rogue cog

Possible, but the previous bearing was original. and i have reused the outer race.

I called and managed to speak to Colin, He has had to suspend work to look after his 93 year old father. He is not taking any orders for the moment.

hi, without the mainshaft in position the bearing rollers slip in easily but it seems impossible with the mainshaft in, with the reverse idler held up.

friend experienced in gear boxes cannot get layshaft home