brianp38dse's latest activity

This will undo the security bolt https://www.ebay.co.uk/itm/145935147851

For new keys, it is go to JLR dealer and they order you a new one pre programmed for a lot of money or have a chat with classic rides north wales who can sort out a clone key which is probable your best bet, there was a guy on here @MrSporty who...

Check no leak off pipes are leaking onto the FIP and making it look as though the pump is at fault.

I believe on that year of l322 the bmw inpa software will work and is about £80 for the software and cable and will save you having to get someone else to plug it in.

You wont get a doozel reclassified no way will the nox levels be low enough, but has work only on the 4.0lr petrol with the bosch injection system

Have a set of these on there now but i do like the Comet ones that @Henry_b has they look the biz with that colour blue

What about these ones mine had them when i first got it

A few on here have done that to get there 4.0lt p38`s compliant for the ULEZ

LR slipped up there :rolleyes: But then my 37 year old classic is still free of any serious corrosion & has parked in the open for the past 16 years. The secret is spending money on rust prevention treatment, rather than accessories.

The carb is an hif44 and the dizzy is later electronic one, looks to me its had a mg metro 1275 dropped in

Was the brake light switch set correctly when it was fitted, then are not just a one in one out job.

"Yes, I belive it is legal. Yes officer..."

The pic we wanna see is the look on the amblumance drivers face as you try explaining how it got to this point

It would involve an engine and management swap and a whole lot more that is if it is even possible, it would need adblue tank and far more cost than getting one that is compliant, other option is to go for a petrol one and spend the money you...

That may work but they are in to alloy so may be a bit corroded if the fan works ok when tested leave well alone.

They are shear bolts designed for the nut part to come off when its tight you can undo the with a few tools

If you have to work on gravel put a sheet of 12mm ply down makes it a lot easier to move the jack about and slide yourself about on, i even use a sheet of hard board on block paving as things move so much better and it catches any oil and gunk.

ERR3561

They are on fleebay there is a used one for £19 or new going up to £70

If its attached to the fuel filter housing its the MAP sensor about £40 new

https://www.ebay.co.uk/itm/387633631141?_skw=liqui+moly+1538+rubber+treatment+500ml&epid=7029619724&itmmeta=01JHD2HG0NNR1R6HWEA8KEXAQF&hash=item5a40c3cfa5:g:DlkAAOSwIbVnPd6I&itmprp=enc%3AAQAJAAABAHoV3kP08IDx%2BKZ9MfhVJKmchk3Q8swGLHbn3hgMU7u6FCrOpZ...

Try this thread for the download https://www.landyzone.co.uk/land-rover/rave-and-microcat-downloads-plus-other-useful-info-on-range-rovers.322195/

looks good as it is :) just give it an oily rag restoration.

And the waste joints with stand allsorts of chemicals and ****e pored down them

So your car is now properly re-volting? :)

Leaky :)

About £15 if your lucky :vb-biggrin:

That ecu will be wabco b