Recent content by briam352

Just fitted a NAHTDDEFTOP - Top Mounted Rear Gas Strut. Bit pricey compared to others but best mod I have done so far. The close assist gives a lot more confidence with my dogs in the back that the door will stay shut. And the soft opening stops me launching a pedestrian into next week. As...

I have a new master I purchased at the same time, will swop and bleed

It is the original although I had the fork and Bering replaced when the clutch was changed.

Hi All, hope you are all having a great day and enjoyed the recent good weather (UK). I have a 1987 LDV90. (Old Blue) I have recently had a new clutch installed and at the same time, due to a leak I replaced the slave cylinder with a very cheep britpart AS07. Since its now back on the road I...

Too tricky for me as an armature home mechanic, got Diesel Bob to sort it.

Hi All, hope you can help once again? I am putting the cam belt back on my 19J after having the fuel pump reconditioned and have aligned everything to the TDC dots and arrows, question I have is this. On the fuel pump cog there is an F mark. What does this relate too, I find no mention of it...

Manged to recover circlip and washer. Woohoo!!!! Question, what is the throttle position when putting to cover back on. Is it in the fully open position when re assembled and how do I align the cold start leaver? I have noticed that the regulator plate jams if slightly twisted and I think it...

Found the problem when I went back in, the circlip on the bottom of the throttle has come off and gone missing. Could be anywhere inside. New pump require I think :(

Can find loads on the dpa but not the dps. :(

Thats plan B. I am lucky that it is not my primary transport so I have time and can try and work through it.

I have changed the cover gasket on my 19j DPS pump. Have put it back together. The control next to the throttle (dont know its name feels a bit stiff as if its rubbing but don't know on what. I took care to align it with the plate below. I ensured that the top throttle plate located correctly. I...

Has anyone got a diagram/rebuild instructions of the 19J Cav Dps injector injection Pump 8520A290A type 621. I took the head gasket off to replace but not sure I have put it back correctly. Have blead pump but wont start. Looks line no fuel going to the injectors.

I have a 1987 LDV90 and I really want to put black vintage number plates on it. I know its not legal in the UK as its not pre 1980 but I do see them every ware. Has anyone on hear been fined or is there a warning first?

How did you get the slider out? Did the cam need to come out?

Yes its a composite, thanks