aaronparke1's latest activity

Hmm, perhaps it should. It isn't doing so though.

Anyone know anyone in Stoke on Trent area with this old school tech?

Snap on doesn't work with the p38 you need to go old school

I've driven it plenty of late but it doesn't clear

See your other post.

Not sure but I think it should clear itself if the fault is fixed. You need a Nanocom to see what is going on.

My local garage has an up to date snap on diagnostic tool and it has cleared all the faults in the memory. It shows "no faults" but the digital readout when turning on the ignition still says "traction failure" and my ABS and TC lights are on.

Hi all, Anyone close by me with software to clear my Traction Failure? I had put disco 2 hubs on but the sensors threw up an ABS and traction Failure. I've reverted to the proper P38 hubs and the ABD failure has cleared but I'm left with the...

They do work, they fit just as the P38 hubs it is just the sensory issue. The old hubs were knackered so it wasn't an option to just replace the bearings, the reluctor rings were rusted through. I have P38 hubs and fitted them. Now no ABD fault...

Because they were much cheaper and I believed they would fit and work.

I guess it depends if the reluctor ring has the right number of pulses and if the sensor gives the correct voltage

I guess my question is who has already been here and what was their solution?

Hi all, So, clunking when on full lock led me to decide to replace the front CVs on my 2000 P38 4.6. This led me to discover my hub bearings were knackered and the drums on the back of the hubs that the abs sensor picks up from were shot too...