Most systems test for vacuum for half an hour ish to make sure there are no leaks. So assume yours hasnt do you know how much gas they put in ? Most new systems take about 400 grams the p38 takes 1250 grams so if you do a recharge and they only put 400 grams it wont work too well Also the...

If you dont sort it soon you will be buying new door locks for the front as the motors will burn out

Put your location up as next time someone may be local and can help

Go back to the post list and it is at the top

You need to get underneath take the plate of and see what is going on

I got one from Island about 6 months ago they were the cheapest at the time

Nothing at all no gasket needed it is a dust cover for the torque convertor

2 things first is the sunroof set as in open and closed fully in a continuous motion . 2nd have you inspected the fuse box under the bonnet these fry themselves after about 8 yrs roughly this is of course as well as the RF receiver not instead of . Lots of odd faults thrown up by bad battery...

If it is a V8 it is dry behind it that is if you are talking about the half moon blanking panel

+1 I use an old toshiba

Question for those that have put exhaust on with the Janspeed is there a noticeable drone on the motorway at say 70mph

If you are getting the erratic volume in the expansion tank in my experience this is caused by air in the system could be getting in anywhere but check the hose fro the top of the rad to expansion tank isnt airlocked - try running with the cap off rev to 1500 to 2000 and you should get a steady...

Just returned 2000 mile round trip after fitting replacement engine and never missed a beat :D:D

Same in Kuala Lumpur and in some parts of Africa loads of cash around for the few

Hope you are not admitting that your teeth are in a glass by your bed and this was the only use for said brushes :D:D:D

Most have a gallon in there but not in a container:D:D

+1 maybe there is a reason they dont want it to start ;)

Sorry rob just noticed you say it is lpg so trick is to run at approx 2000 revs with cap off and if poss clamp the feed to the vapouriser therefore purging the matrix - check the t joints abnd make sure you dont have a slight weepmine did but of course evapourated before you could see it and...

Do you have lpg installed ? If so the heater matrix can be bypassed by the vapouriser and air can get trapped in the matrix it moves inside the matrix and when revs reduce it trickles back down and it is an absolute mare to get rid off this I know from experience

+1 prob sensors need reseating