craddocks do the correct ones. fit perfect but not cheep.

get somebody to hold the brake pedal down and try for play, if play still there it will be swivel, if play gone it will be wheel bearing

is it a series 2 with 2 wiper motors. they could be the earth wires to the motors

Looks like a late series 2a with the maltese cross grille. If it has instruments in the center of the bulkhead then nits a series 2a but if the instruments are in front of the steering wheel its a series 3. the windscreen hinges and the door hinges are also series 2a

if that's a picture or your landrover then the bulkhead looks very repairable to me. worth getting a good welder to look at it. many repair panel out there very cheap

You do not have to buy it. If nobody bought at them prices then the prices must drop

Just rewired my series 2 fitted with a 2.5 petrol and alternator. Did not want to fit off the shelf loom as I would be making many alterations so I bought a new loom off ebay that the seller did not know what model it was off , this I completely stripped out so I could use the proper coloured...

with the amount of mods on this it may not be mot exempt

most likely a series 2. the screen and roof look like defender. I am just putting back a series 2 that had a seventies facelift to series 3 lookalike. can cost a lot to get it back to original but you can keep it as is . has it got a v8 in it

Has it got a central dash or plastic in front of driver

Hole in right hand wing looks like it had a flexi hose going to a fresh air vent behind the front centre seat facing second row seats. Took about 10 mins to get started with fuel down carb. oil light went out and alternator charged. result

is it still original in the rear, and most important whats the chassis like.? pressure wash it and it will look loads better

tie a pitbull to the front bumper

you could use a bead of silicon

Sounds like it may be the carb flooding. time for a new needle valve perhaps

the door looks to be built just like the original only taller.

deal done.

not for snorkel as lower than carb and on wrong side

the hole is on the drivers side wing and is smaller than a series 3 it has a coller going in about 3 inches looks like it had a hose fitted to it. The headling above the front compartment is the same hight as normal land rover roof so has a 6 inch gap between it and the raised roof so making a...

its a diesel so no carb