Dippypud · Aug 30, 2013

Changed the air filter and fuel filter today

Gonna have to do the intercooler soon ...

timtheenchanteruk · Aug 30, 2013

Yep, n they don't give any notice, with landys it's fine... Fine..... Fine.... Cough splutter, dead

RealSillyTilly · Aug 30, 2013

suew said:
On my way outside to put the Landy back together

Wish me luck

Good luck, I'm putting mine back together tomorrow, and Sunday and Monday...

Big Mat · Aug 30, 2013

Changed the rear door lock as the old one was very tempermental and i didnt want to leave it unlocked in the marsh car park.

Will give it a clean and check all fluid levels tomorrow.

defender11069 · Aug 31, 2013

went night laning in it with a load of LZ looney tunes wos a very good night

sarah90 · Aug 31, 2013

defender11069 said:
went night laning in it with a load of LZ looney tunes wos a very good night

Oooh me too

....now I have to go see where the bolt went on my rear door lock

Ttuck3r · Aug 31, 2013

Fitted new windscreen an new seal, some job for a first timer on his own!

myfirstl322 · Aug 31, 2013

N/s rocker gasket on my 4.4 L322, did O/s, bit of a bitch, but N/s has more stuff in the way, ie, Lpg vapouriser, some sort of coolant valve and stuff
Grazed knuckles and a boot in the balls for the dog i foresee

NOT my dog, heavens above. Its my M8's.:cool2:

landowner · Aug 31, 2013

Ttuck3r said:
Fitted new windscreen an new seal, some job for a first timer on his own!

How bad of a job was it, I'm thinking of attempting this soon

Ttuck3r · Aug 31, 2013

landowner said:
How bad of a job was it, I'm thinking of attempting this soon

It would be an easy job if you can get help to apply some pressure from the outside whilst pulling in the cord on the inside, and get some soapy liquid around to help the process.

Kwakerman · Aug 31, 2013

New Timing belt kit, water pump, P gasket & radiator (re-cored) fitted and all working

landowner · Aug 31, 2013

Ttuck3r said:
It would be an easy job if you can get help to apply some pressure from the outside whilst pulling in the cord on the inside, and get some soapy liquid around to help the process.

Wonder if a rubber with an insert (like Minis etc) would do the job, might not be as tight a fit until the strip goes in and that's easy with a tool

Kev@kenninghall · Aug 31, 2013

New front dampers and galvanised heavy duty turrets. What a sod getting the old one out!

Had to take the angle grinder to the old turret and take it out in pieces.

OxonLandy · Aug 31, 2013

Ttuck3r said:
Fitted new windscreen an new seal, some job for a first timer on his own!

good job

SteveD · Aug 31, 2013

Ordered a bumper and hockey panels. Just need to take a hammer to the bonnet and we are good to go

bluehaze · Aug 31, 2013

Steve, which bumper have you settled on?

scottant · Aug 31, 2013

Fitted 2 rear shocks (yesturday i admit but close enough) and started sorting out my new light bar

got to wire it up tomorrow and it'll be good to go. Oh and ive got to check the range rover over before peterborough.

buckshot · Aug 31, 2013

ordered a 175 amp alternator off the bay, should negate the need for twin batteries and split chargers

Freelaner · Aug 31, 2013

dunt that put all yer eggs in the same basket though?

buckshot · Aug 31, 2013

course it does how often do you use a winch I aint doing winch challenges.
have been with more than 1 landy with twin batteries that couldn't keep up with their winch , that baby wont take bugger all out of the battery.
lad that gave me the link on the bay uses one on his 8274 without 2 batteries

Never Knowingly Understood

Well-Known Member

New Member

Well-Known Member

AKA Mr cool...

Well-Known Member

Active Member

Well-Known Member

Pensioner Pete

Active Member

Well-Known Member

Pensioner Pete

Well-Known Member

Active Member

Senile Member

Well-Known Member

New Member

Well-Known Member

Landy Driver

Well-Known Member

Similar threads