chunkymunky
New Member
If you put lorry heated seat pad into that special blagging place they are there
If you put lorry heated seat pad into that special blagging place they are there
chunkymunky
New Member
Looks good. Is it staying now?
chunkymunky
New Member
There are plenty over there already. Get one there maybe?
Dr No
Active Member
That's the general idea cash permitting, depends on how my job hunting works out.
not a harley rider
Member
Eventually got around to replacing the motor for the front window, replaced the springs in the rear door two days ago, so as it is there is nothing not working correctly on the car at the moment...............
easye1
Banned
finally wired two foglights up, through dip beam as a feed to switch then to the relay on.
bit of luck I can see at night!
I also fitted a splash guard, cut down from a diesel mondeo one I had, held onto the chassis by big (B I G) cable ties.
I got fed up losing my alternator & power steering in splashy wet "puddles"
and "stuff"
If it gets buggered, it cost me nought to start with..
bit of luck I can see at night!
I also fitted a splash guard, cut down from a diesel mondeo one I had, held onto the chassis by big (B I G) cable ties.
I got fed up losing my alternator & power steering in splashy wet "puddles"
and "stuff"
If it gets buggered, it cost me nought to start with..
defender11069
AKA Mr cool...
turned my pump down 1/2 turn now i can see were ive been still got the power lol
Thought I had better get my ass of the sofa and replaced rocker box gasket,checked and adjusted tappets and cleaned breather,drained clutch fluid and replaced with new( took 5 pots of fluid to flush through the system until I got clean fluid) and checked all wiring relating to fuel and temperature gauge and I still can't get them working ? But I did get a few jobs sorted.
DEFENDER90-DAZ
New Member
Stuck on a rather dashing "DEFENDER 90" decal on the back just below the landrover badge (where it should be)
Daz
Daz
chunkymunky
New Member
Fitted me new seats from vilguy , they're out of a smart car and look great.
Easy fit? I see the back is thinner so goes further back?
Changed a bolt.
chunkymunky
New Member
Awwwww you must be knackered. Put yer feet up
big si
Well-Known Member
They sit about the same, just a little tighter due to truck cab back, in a van they'd be perfect mate. Really easy fit just drilled 2 new holes and there in
I am
mind yu - helping Snifflebag fit front diff guard, steering guard and fuel tank guard to his motor mite have summat to do with that
.
