Picked up some bolts for the towbar but forgot to get two long ones for the drop plate to rear chassis rail :doh: need to get more tomorrow then I can fit the bugger


Its gonna stop people in corsas getting too close to me from now on :rolleyes:
 
had a 101 heater blower posted to me......deciding wether to replace the heater fan with it or try to plumb in some extra pipework and install inside :der:
 
jamesmartin said:
if you get stuck i may have a used housing on a scrap motor ,not much fun to fit but kind of important
Click to expand...

thanks for that jm will be in touch if the re-thread route is a non starter :(
think either way its going to be a bitch:mad: cant believe the engine designers would put the oil pipe for the turbo so tight up under the filter cartridge :mad::mad:
 
assembled roofrack version 2 in my disco 1 , now wondering what sort of lights to put in front on rack? any thoughts? foggies or spotlamps, worklights? ALL?
 
buckshot said:
did the oil change as the roofing job lined up was a no no in this wind :doh:.
when i took the cap off the rotery filter noticed the bolt on the engine side of it was a tad loose :rolleyes:, when i put it all back together bastid would'nt tighten at all :mad: turned out the fookin numpty who did it before i had the landy must have lost 1 of them bolts and replaced it with a normal M6 bolt (not the same thread :mad:).
will only do up hand tight seems to be ok no leaks will have to do something wityh it over the weekend (any ideas anyone? sarky answers on a post card :mad:)
Click to expand...

mines the same, i past a bolt right through and using extending magnet you can get a nut on the back, its tight for space though
 
johnlad said:
mines the same, i past a bolt right through and using extending magnet you can get a nut on the back, its tight for space though
Click to expand...

have sorted it for now (how long it holds is anyones guess )


mnmn010.jpg


cut the head off a m6 bolt and filled up the threaded hole with chemical metal then threaded it into it , left it for a hour then cleaned off the dross fitted the cap and tightened a nut down. have'nt done it up murder tight but does'nt need to be it has a O ring to seal it (wont be as slack as it was before and it did'nt leak for over a year.
 
Series71 said:
had a 101 heater blower posted to me......deciding wether to replace the heater fan with it or try to plumb in some extra pipework and install inside :der:
Click to expand...

inside is good I reckon......recycling air through a heater gets a lot warmer than trying to warm freezing air from outside
 
Vagrent said:
Reversed into a Renault megane:mad:
Click to expand...


The lady is single, fit and is happy to 'work something out, no need to go through insurance'

I am either gonna have to pay ****ing loads for a new light or she will insist on sex on tap as payment whilst I am at work (it was one of the residents on the site I work on)



Please please please be the latter:D:D
 
You must log in or register to reply here.

Similar threads

B
defender 2.4 puma reverse light switch
Replies
4
Views
472
BEASTIE 90
B
Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
574
Padda.116
Padda.116
Knappster
Shot-blasting steel wheels
Replies
9
Views
835
Knappster
Knappster
Mooky
Replacing thermostat
Replies
8
Views
245
Forrest Gump
F
I
Re-coding of ABS Module after repacement
Replies
10
Views
919
invisible999
I