I didn't realise you could clean them.
I didn't realise you could clean them.
It can get caked up with diesesed crud which will impact how well it works.
You can get map cleaner spray, but I've got electrical contact cleaner so used that.
It's not had any detriment and the crap that came out can't have been helping anything
He had a magical time
Datatek
Well-Known Member
Every 4 months? You must have money to burnNice day for once so gave the engine an oil and filter change. Do it every 4 months anyway. Only seems like yesterday I did the last one. Where has time gone
Every 6K miles or 12 months is more than enough.
Scotiawhiskers
Well-Known Member
Don't know about the MAP sensor, but cleaned Otto's MAF sensor by plugging the outlet sides with cotton wool and standing it vertical with the inlet uppermost, then filling it with isopropyl alcohol and letting it drain through slowly.
Then took the cotton wool out and gave it another rinse through with the isopropyl.
Let it dry, reinstall, all much better.
rich28uk
Well-Known Member
Must say sometimes my oil change is every 4 month, I go roughly every 7000 miles which can be 4 months.Every 4 months? You must have money to burn
Datatek
Well-Known Member
You have covered the miles so fair enough.
doriz
Well-Known Member
Was it just flat at the bottom?Drivers rear tyre was a bit low today.. looked ok yesterday
Yea, it's always the way!!
doriz
Well-Known Member
Maybe you should bring your tyres in at night to keep em safe n warm.Drivers rear tyre was a bit low today.. looked ok yesterday
I think it's a problem with the large 4x4 tyres tbh.. so much air in them and when it's cold overnight, the heavier air molecules separate to the bottom, causing the flat spot
badfluffy
Well-Known Member
hold the water so the panels rot out from the inside
1988smithy
Well-Known Member
NVH I suppose
