Hi all
I am prepping the bulkhead of my series 3 for repair, pillar/floor replacement etc.
Question... Does the bulkhead fit vertical/90 degrees to the chassis as viewed from the side? I want to be able to check the position after removal. The chassis currently is level to the ground checked with spirit level.
Fitted at the moment the bulkhead is about 15 mm out from the outriggers and up against the two chassis supports in a vertical position.
I just wanted it for accuracy in repairing.
Hopw this makes sense.
Cheers Peter.
I am prepping the bulkhead of my series 3 for repair, pillar/floor replacement etc.
Question... Does the bulkhead fit vertical/90 degrees to the chassis as viewed from the side? I want to be able to check the position after removal. The chassis currently is level to the ground checked with spirit level.
Fitted at the moment the bulkhead is about 15 mm out from the outriggers and up against the two chassis supports in a vertical position.
I just wanted it for accuracy in repairing.
Hopw this makes sense.
Cheers Peter.